Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
What is the proper engine operating temperature for a 1987
What is the proper engine operating temperature for a 1987 Silverton with Crusader engines… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 2003 silverton 330 sport bridge with twin crusader
i have a 2003 silverton 330 sport bridge with twin crusader 8.1 engines. It is not getting power at the starboard ignition switch at all … read more
AntonioC93
AntonioC93
Marine Service Manager
International Business
217 satisfied customers
I have a 1990 Silverton 41 aft cabin with twin Crusader 502
I have a 1990 Silverton 41 aft cabin with twin Crusader 502 engines. 609 hours each. The starboard engine started to rev up at about 3000 rpm. Would drop down again, after a short time it would do it … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have crusader 454s and the starboard engine runs fine for
I have crusader 454s and the starboard engine runs fine for about 15 minutes and then slowly looses power. My mechanic said it needed a rear transmition seal and he replaces it. The engine was longblo… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
403 satisfied customers
I have 2 454 Injected crusaders on my 1996 372 Silverton,
Hello , I have 2 454 Injected crusaders on my 1996 372 Silverton, the fuel lines have been replaced yet when it runs on idle in dock and then put it in gear it would stall (under load) it is the starb… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
1987 bluestem bost with 2 454 crusader engines. Started up
1987 bluestem bost with 2 454 crusader engines . Started up for season . Both started fine ... we let them run for about 39 mins . The starboard engine cut out and would not start up again although it… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have 1997 crusader 454 ego engines. Port engine runs fine
I have 1997 crusader 454 ego engines. Port engine runs fine for short period of time and then looses rpm. Have replace distributor and coil. Ran boat at 2000 rpm for about 30 minutes and same thing ha… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have 1990 Silverton 34C with 454 crusader engines many
I have 1990 Silverton 34C with 454 crusader engines many years of great boating A problem this year is the starboard engine will not go over 2,000 RPM when running in gear. At the dock it will rev to … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1996 Carver 355 aft cabin with twin 454 crusader XL
I have a 1996 Carver 355 aft cabin with twin 454 crusader XL engines. My starboard engine runs fine after runing it for about an hour. When I sart it back up the engine won't run over 2500 RPM's and p… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
403 satisfied customers
I have twin crusader 1997 454 xli engines with borg v drives.
I have twin crusader 1997 454 xli engines with borg v drives. On a recent trip 2 hrs into our 3hr trip the port side engine RPMs dropped to 3000 normally cruise at 3400. Port engine no longer goes abo… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
3,332 satisfied customers
Good evening, I have a 2002 Silverton 352 with twin Mercruiser
Good evening, I have a 2002 Silverton 352 with twin Mercruiser 8.1 Horizons. 370 hours. Boat runs excellent. Port engine lately will not achieve rpm over 3700. Starboard will WOT at 4150. The throttle… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
3,332 satisfied customers
After running for approx. 45 minutes my starboard engine starts
After running for approx. 45 minutes my starboard engine starts to loose rpm and I have to back off on the throttle from 3400rpm to 3000rpm to keep it from surging. I've changed the fuel filter (PS-38… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 454 crusader port engine that starts very hard when
I have a 454 crusader port engine that starts very hard when cold but no problem once it starts even if I leave it off for three or four hours. Overnight and it starts very hard with a lot of cranking… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
Crusader 454 XL engine - engine will not drop below 1000 RPM
Crusader 454 XL engine - engine will not drop below 1000 RPM after running above 1500 RPM. Engine runs strong, starts easily and shuts down. Looking for help getting the RPM to drop below 1000 when th… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
we have a 35 1989 Carver aft cabin yacht with Crusader 454
we have a 35' 1989 Carver aft cabin yacht with Crusader 454 engins. When underway @ 3k rpm, we noticed white smoke coming from the port engine in the size of about one cubic foot and about 6"x 6" on S… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 1996 361 Silverton 361 express with Crusader 454 330hp
I have a 1996 361 Silverton 361 express with Crusader 454 330hp engines 5.7 liter xl series.The problem I am having is the ignition relay in the electronic control module . I gets very hot and causes … read more
Greg Robinson
Greg Robinson
Senior service manager
Vocational, Technical or Trade Scho
199 satisfied customers
I have a 1995 silverton with 454XL crusaders, electronic ignition,
I have a 1995 silverton with 454XL crusaders, electronic ignition, throttle body fuel injection. It runs fine at low RPM's but when I put it under a load (2300 rpm and climbing) the starboard engine w… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have 1996 crusader 454 XL 330 hp throttle body engines on
I have 1996 crusader 454 XL 330 hp throttle body engines on my 1996 Silverton 361 Express. There is a relay in a black box on top of the engine that gets extremely hot and causes the engine to mis fir… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x