Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Motor starts out fine brings boat up on plane runs nice for
motor starts out fine brings boat up on plane runs nice for 2or3 minutes then starts to bog down for a while then will run again for short time then bog again … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Accidentally got water in fuel drained tank took carbs off
accidentally got water in fuel drained tank took carbs off cleaned with carb cleaner and air runs good but pull into full throttle runs for a bit then dies brought home took off fuel pump and took apa… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 2010 mercury 350 mag engine, a problem started with
I have a 2010 mercury 350 mag engine, a problem started with engine stalling while trying to get on plane, I could ease into throttle and boat would run but would stall under full load. I figured that… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 1989 120 HP outboard on a 16-ft bass boat. It will
I have a 1989 120 HP Johnson outboard on a 16-ft bass boat. It will start, idles bit fast (around 1000 RPM, and goes in gear w/o any difficulty. Using the throttle advance lever while in Neutral, the … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
2004 50 hp johnson. engine ran fine most of the day. when returning
2004 50 hp johnson. engine ran fine most of the day. when returning to the dock i tried to get boat on plane. It wouldnt give me the throttle power or rpms to do it. wondering what i should check.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Suzuki dt140 revs to over 6k rpm in neutral - in gear only
Suzuki dt140 revs to over 6k rpm in neutral - in gear only gets to 4k and then bogs down, loses power?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
75hp Merc 1985 4cy,2st. Motor Bog issue. Bought this used with
75hp Merc 1985 4cy,2st. Motor Bog issue. Bought this used with bad starter. Replaced it, cleaned carbs, new fuel tank and lines, new fuel pump kit, new plugs, 110 comp. check on all 4cyl. Got it out o… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
i have a 1996 Mercury 3.0 efi that bogs down when i accellerate.
i have a 1996 Mercury 3.0 efi that bogs down when i accellerate. i have had it a few months and the motor runs fine at idle and once it catches itself and planes the boat out and runs fine it will bog… read more
Malta Tech
Malta Tech
Marine Tech
High School or GED
287 satisfied customers
Triton tr20 with a 1999 225 ho engine--carburated--6 of
triton tr20 with a 1999 225 ho johnson engine--carburated--6 of them---when u get on water run for a while get to fishing spot--cut engine of fish for a while--go to crank it up--it usually does but d… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
2003 johnson 90hp 2 stroke misfires under load. model #j90plstc.
2003 johnson 90hp 2 stroke misfires under load. model #j90plstc. Boat has perfect compression and what looks like a great spark on each cylinder when put clear spark tester on. New fuel water seperato… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Im having a problem with low idle and a primer pump bulb not
I'm having a problem with low idle and a primer pump bulb not staying firm on a Johnson 115 motor (1995). I just had the boat in for tune up/repairs and first time I took it out it started and ran fin… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
i have a 2006 johnson v6 150hp, this engine was serviced early
i have a 2006 johnson v6 150hp, this engine was serviced early in november of last year and the engine was not performing as it should, the owner brought the boat to my workshop and i adjusted the flo… read more
Master Tech
Master Tech
Marine Technician
Vocational, Technical or Trade Scho
1,168 satisfied customers
HI....my boat was running full throttle across the lake when
HI....my boat was running full throttle across the lake when it changed sound and gradually lost power. It starts fine and will move when the throttle is low. When I go full throttle it will not do mu… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
My husband and I launched our 1995 Generation III pontoon boat
My husband and I launched our 1995 Generation III pontoon boat last weekend. It started fine on land. The boat was running fine at 2000 rpm. I increased the speed to 3000 rpm and heard a noise like so… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1984 Johnson 65 Model J65WTLCRS (that was running
I have a 1984 Johnson 65 Model J65WTLCRS (that was running great) and when I try to speed up and get on step the motor is bogging down and will not get on step,but if I push in the electric chock butt… read more
shane j forrest
shane j forrest
Vocational, Technical or Trade Scho
270 satisfied customers
I have a 1986 Johnson 110 outboard. when we accelerate to get
I have a 1986 Johnson 110 outboard. when we accelerate to get boat up on plane it doesn't always go. It seems like it is bogging down. After a while the rpms do increase and boat eventually does achie… read more
The Man on the Dock
The Man on the Dock
Marina Owner, Operator
Vocational, Technical or Trade Scho
74 satisfied customers
I have a 1978 Johnson 70hp that has a what seems to be a misfire
I have a 1978 Johnson 70hp that has a what seems to be a misfire under load and will not rev over 2500-2600 rpms. It runs fine on the muffs but not during water test. The carbs were rebuilt, the compr… read more
Dr. Joe
Dr. Joe
Bachelor's Degree
198 satisfied customers
I have one engine that ran fine 2 days ago. Yesterday the engine
I have one engine that ran fine 2 days ago. Yesterday the engine would only reach 2900 RPM then sputter, knock, and drop off. This got progressively worse as the day went on 2500, 2300, 1800, 1500, an… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x