Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
While docking our four winns h350 Volvo penta 380 inboards
While docking our four winns h350 Volvo penta 380 inboards 2016 year. While coming in at approx 1200 rpm. We were going to hit the dock and pulled them both to reverse. The right engine cable from act… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
403 satisfied customers
My 1986 omc 4.3 liter cobra outdrive trims up and down fine.
my 1986 omc 4.3 liter cobra outdrive trims up and down fine. However when it is under power the bow does not trim well. I have to have someone sit in the front of the boat to get it down … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I own a 28' Four Winns with twin Volvo 5.7s and SX Cobra
I own a 28' Four Winns with twin Volvo 5.7s and SX Cobra drives. The other day the port engine began over revving while cruising. I backed down the rpms. I was able to increase rpms to 1800 when it ag… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
My boat will not engage the propeller. I have 1986 Chaparral
My boat will not engage the propeller. I have 1986 Chaparral 200 XLC. On the first cruise of the season I was moving then the boat stalled. After I got the boat started is when the propeller would not… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Just today my boat started loosing propulsion when
just today my boat started loosing propulsion when throttling from idle up to plain. when lost, engine revs up and nose of boat pitches down. loss occurs within a few seconds of throttle up. just enou… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
i have a 97 31 ft cruiser with two 5.7 lx and bravo out drives. I noticed shorly after get
i have a 97 31 ft cruiser with two 5.7 lx and bravo out drives. I noticed shorly after getting on plane one of the engines rpms took off like it went into neutral. As i tried to get back on a plane it… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
i am looking at a 1982 boat, with a 3.8 litre gm v-6 (1300hrs)
i am looking at a 1982 boat, with a 3.8 litre gm v-6 (1300hrs) connected to an OMC stern drive. Boat is in excellent condition, has been winterized every year, new filter and oil annually. Two questio… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
i have a 1988 four winns 160 freedom with a 3.0 omc cobra 120
i have a 1988 four winns 160 freedom with a 3.0 omc cobra 120 hp motor. i am having top speed issues and noises coming from either drive system or motor. scenerio: when im just in gear moving at a slo… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
i have 2000 mercury 150 sws . boat usually runs top speed of
i have 2000 mercury 150 sws . boat usually runs top speed of 35mph but recently has only been top speed of 24 mph. any sugestions?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a alpha one stern drive. I just replaced the water pump
I have a alpha one stern drive. I just replaced the water pump impeller, and put the lower geat housing back on. Now every time I put the boat in gear it stalls.… read more
Scott Martin
Scott Martin
Service manager
Vocational, Technical or Trade Scho
167 satisfied customers
i have a 1973 caravelle with a omc stern drive and the prop
i have a 1973 caravelle with a omc stern drive and the prop speeds up and down in forward or reverse out of the water. when I go in the water it only idles forward and reverse its on revs up like the … read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
just bought a boat, took it out for a test drive and idle speed
just bought a boat, took it out for a test drive and idle speed was fine but when i went to accelerate the motor would increase rpm but the boat speed was barely noticeable and when it got to around 5… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
1994 Yamaha 115 2 stroke outboard w/ 704 Yamaha Remote Control
1994 Yamaha 115 2 stroke outboard w/ 704 Yamaha "Remote Control" was cruising along just fine. Coming in to dock, shifted to neutral, then reverse to complete docking. motor stayed in neutral (tho con… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 96 carver 250 express cruiser with a 7.4 liter engine
I have a 96 carver 250 express cruiser with a 7.4 liter engine and bravo 3 drive. I had the boat out this afternoon and on the way back from a 30 minute run around the lake I lost all thrust from the … read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,746 satisfied customers
Boat gets into gear but adding power above 1000 rpm and engine
Boat gets into gear but adding power above 1000 rpm and engine will spin faster but prop does not. Prior to this we had been running fine for about 1hr, then while pulling a tube and doing a few aggre… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 97 Maxum with a 3.4 liter Mercruiser in it. I pulled
I have a 97 Maxum with a 3.4 liter Mercruiser in it. I pulled it out after a long winter and it started right up. Engine sounds great (had major service last fall). I also had both my props rebuilt ov… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 4.3 litre V6 Mercruiser with an Alpha one outdrive.At
I have a 4.3 litre V6 Mercruiser with an Alpha one outdrive.At full throtle the rpm's max out but the Prop doesn't come along for the ride.At 45 mph the trouble starts, but the boat doesn't speed up a… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have the boat listed below and wouuld like to take the 2
I have the boat listed below and wouuld like to take the 2 X AD 31 130hp Engines out and put a single Yanmar 6BY260z in and wonder if you could advise on the ratio of the drive leg, it will be a bravo… read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x