Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a mercruiser with a Alpha 1 Gen 2 drive. I'm changing
Hi, I have a mercruiser with a Alpha 1 Gen 2 drive. I'm changing the impeller with the quicksiver kit 47-8M0100526/27. I have an o-ring that was included with the kit that I'm not sure where it goes. … read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
Yamaha F-20 - replaced water pump impellor with the kit -
Yamaha F-20 - replaced water pump impellor with the kit - started out OK, with reasonable stream of water - after about 20 minutes, indicator showed overheat and the output stream had stopped. The mot… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
2,043 satisfied customers
JA: . What is your issue regarding? Customer: I have a 1960
I have a 1960 Merc 400 short shaft 45 hp. I was about to replace the impeller and notice gearbox oil in the impeller housing and also in the cooling tube going to the power head. I had noticed the gearbox contained only water at the end of the season. So I need to replace the shaft seal, or the entire water pump housing. How do I do this? Thanks. … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
4.3 MPI did merc up-date from 1 o-ring and plastic base ring
4.3 MPI did merc up-date from 1 o-ring and plastic base ring too 2 O-rings under the injector? for clarification on removing the injectors there was one o-ring and then a plastic type of "seat" in the… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Hi, I am in australia, I have bought a 28ft Bertram 1987, the
Hi, I am in australia, I have bought a 28ft Bertram 1987, the current engines are GM 305 260hp carbie inboard shaft drives with counter rotation. The engines are unservicable, Compression loss, Starte… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Looking for the raw water impeller part number for a marine
Looking for the raw water impeller part number for a marine diesel generator (Westerbeke). The pump looks like the Westerbeke 33636 pump but it has an "O" ring instead of the paper gasket. It's a 7.5 … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
i have a mercruiser 350 mag mpi. i revved the engine loading
i have a mercruiser 350 mag mpi. i revved the engine loading on to trailer out of water. next day i put it in, now the engine is running hot. seemes no water is being picked up.. i checked under the b… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2004 amberjack sea ray with new merc cruisers 454S
I have a 2004 amberjack sea ray with new merc cruisers 454'S COULD YOU GIVE ME AN APPROXIMATE FISHING RANGE ONE COULD EXPECT FROM THIS SETUP.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1997 Johnson 175 (J175EXEUC). Want to change impeller
I have a 1997 Johnson 175 (J175EXEUC). Want to change impeller and service lower unit. Do you know if there is a video link that takes you through the steps. I do have the manual, but as you know the … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have an Alpha 1 Gen 2 on a 94 Sea Ray. I have gear lube leaking
I have an Alpha 1 Gen 2 on a 94 Sea Ray. I have gear lube leaking from the raw water intake. I found the shift seal was bad and replaced. When I reinstalled I still have the same problem, just on a le… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,715 satisfied customers
MY IMPELLER PUSHES OUT REAR OF MY HOUSING WORKS FINE WITH EARS
MY IMPELLER PUSHES OUT REAR OF MY HOUSING WORKS FINE WITH EARS FORCED WATER BUT MINUTE PUTIN WATER AND IN GEAR BURNS UP AND MELTS OUT BACK OF HOUSING THE IMPELLER IT SELF DOES NOT MELT THE HOLE METAL … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a johnson I just put a water pump kit in and I have
I have a johnson I just put a water pump kit in and I have water coming out of the 2 exhaust holes at the rear of the mid-section? So I removed the lower unit again to make sure nothing was done wrong… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Chevrolet 350 Cu inch marie engine inboard / outboard - overheat
Chevrolet 350 Cu inch marie engine inboard / outboard - overheat horn comes on when started, goes off when underway, temp gauge does not go too high. where are intakes to check cleanliness? how to che… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hi ! I heard about an injection system kit for a cobra OMC
Hi ! I heard about an injection system kit for a cobra OMC engine (7,4 litre) in replacement of the holley carburettor . I cannot find any in my search . Can you help please ? Thanks a lot Stefano (la… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
I have a mercruiser horizon inboard in a 1998 searay 400 some
I have a mercruiser horizon inboard in a 1998 searay 400 some dealer are telling me that this engine needs to be replaced because of water leaks into the cylinder from the exhaust manifolds. That all … read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
3,847 satisfied customers
1996 454 mag mpi missing timing gauge. how can i set the timing
1996 454 mag mpi missing timing gauge. how can i set the timing or can the guage be replaced?… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
engine wont start oil looks good maintenance up to date mechanic
engine wont start oil looks good maintenance up to date mechanic said hydrolocked, maybe due to impeller failure, but temp gauge never over standard oerating temp and no alarms mechanic say head gaske… read more
gearheadII
gearheadII
Bachelor's Degree
138 satisfied customers
I have to change the impellor on a 2006 Yamaha FT8 ...
I have to change the impellor on a 2006 Yamaha FT8 High Thrust outboard engine. Model FT8 DEP X. This is not a job I have attempted before. I cannot find a source for a workshop manual. Can I download… read more
JamesHorvath305
JamesHorvath305
Owner, President
Associate Degree
30 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

3,847 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x