Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
1974 70hp Evinrude outboard. Max engine rpm in a STRAIGHT
1974 70hp Evinrude outboard. Max engine rpm in a STRAIGHT line is 3000RPM. If I do a HARD turn into a circle, the RPMs go UP to 6000 RPM. On going problem to get boat up to full wide open throttle per… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,744 satisfied customers
So I have a merc black max 150 from 1995, it run like an absolute
So I have a merc black max 150 from 1995, it run like an absolute dream when I'm running it wide open. But if im just in gear barely above idle or trying to put the boat on the trailer trying power it… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
What's the dealer spec for fuel mix on a yamaha 40 hp model
What's the dealer spec for fuel mix on a yamaha 40 hp model C40TLRX I've been running 50:1 but only after I emptied the first tank that came with it. Which I'm thinking was mixed 100:1 mix. Take note … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1993 OMC COBRA 5.0 HO. I loose power with WOT. Only
I have a 1993 OMC COBRA 5.0 HO. I loose power with WOT. Only reaches first some 3000 RPM and by pulling back trottle, I cna reach say 3700 rpm instead of 4500-4700. I checked compression, replaced spa… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
2009 6ly440hp tein engines. When I run the boat for a long(er)
2009 6ly440hp tein engines. When I run the boat for a long(er) periods of time while out fishing for several hrs where we'll be at idle or slow trolling at low rpm for hrs with genset on....when I go … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Group question: Office guys have Evinrude motors, 140hp, 120hp
Group question: Office guys have Evinrude motors, 140hp, 120hp & 115hp, All 1986-1990 models, LV4 and have had problems using recommended Champion spark plug QL77JC4. Want to convert to NGK brand. We … read more
Chris
Chris
Senior Mechanic & Technician
Factory Training
163 satisfied customers
19 foot Bayliner with 150 HP Evinrude took it out saturday
19 foot Bayliner with 150 HP Evinrude took it out saturday on puget sound trolling would troll fine for 20 minutes and the sputter and grind and stop. Found bad plug wire and replaced all wires and pl… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,744 satisfied customers
I took your advice and made sure the waterpump was pressure
I took your advice and made sure the waterpump was pressure tight and it was not,which I remidied by using gasket sealer ,however it still is running oily plugs?Copression is 110 on all three,any sugg… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 84 tiara pursuit with 260 merc and the last few fishing
I have a 84 tiara pursuit with 260 merc and the last few fishing trips the boat has ran fine getting out, and trolling for 3-4 hrs but after pulling lines and heading in both times the engine would cu… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Have twin 200hp Yamaha 1991 ... with in last month each has
Have twin 200hp Yamaha 1991 ... with in last month each has lost power and although run great at lower rpm ... idle etc ... i have lost considerable power and top rpm dropped from 5200 to 4500 and gas… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Question for Jeff G. Jeff you helped me with a rebuild on a
Question for Jeff G. Jeff you helped me with a rebuild on a 2001 Yam. SX250TRX SW Series this past winter. I have had problems with plug fouling after extended low RPM runs,trolling. I asked you about… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have two evinrude 225 fitch 2000. The starboard engine will
I have two evinrude 225 fitch 2000. The starboard engine will not start after running for awhile. It is like the engine is in gear. Power on the gages but turning the key to on does not energize the s… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Hi, I have a Volvo AQ125A with fresh water cooling, no matter
Hi, I have a Volvo AQ125A with fresh water cooling, no matter what I try it always seems to run a little hot, is there a bigger heat exchanger kit that exists for that motor. Or better yet a way to ge… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
My 1994 Evinrude 150HP V6 runs excessively and I mean excessively,
My 1994 Evinrude 150HP V6 runs excessively and I mean excessively, rich at under 2500rpm. It also oil smokes badly some times worse than others. It keeps running but you do not want to be down wind in… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 2006 75 horse Evinrude Etec. Bought it used this year
I have a 2006 75 horse Evinrude Etec. Bought it used this year and it seems to missing/ chugging and stalling at low rpms. It was used to push a large barge used for passenger pick-up for a local raft… read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
I have a V4 120HP Evinrude outboard (approx. 1984-1986) that
I have a V4 120HP Evinrude outboard (approx. 1984-1986) that is currently fine while cruising up to 3000 RPM. As soon as I accelerate past 3000RPM the motor starts shuddering/vibrating and will not go… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have twin 2000 Mercury 225 EFIs The starboard motor runs
I have twin 2000 Mercury 225 EFI's The starboard motor runs fine at 4800 RPM's for about 10 minutes then loses anywhere between 300-500 rpms. After trolling for a few hours the motor seems to run fine… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
i have an evinrude 90. the boat is new to me. the motor will
i have an evinrude 90. the boat is new to me. the motor will run fine (4500-5000 rpms) when first put in the water, but seems like when i hit a wake or rough water it'll die down to 2500 rpms at full … read more
Dr. Joe
Dr. Joe
Bachelor's Degree
198 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x