Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 225 Mercury LEFI 5800 outboard motor. The tilt and
I have a 225 Mercury LEFI 5800 outboard motor. The tilt and trim doesn't work. I have power from the battery to the radio but neither trim switch on the motor and on the drive lever works … read more
CalebA820
CalebA820
Technician
Marine technology
22 satisfied customers
I have recently purchased a 1994 Regal 256 Valanti with
Hello, I have recently purchased a 1994 Regal 256 Valanti with 7.4GL Volvo engine and a DP-D1stern drive. First time out on the boat and when I put the stern drive in the Tilt Up position (approaching… read more
Boat Doc
Boat Doc
253 satisfied customers
I have a 1996 Evinrude ocean pro 175, the trim and tilt
I have a 1996 Evinrude ocean pro 175, the trim and tilt motor went out so I opened the pressure release valve and the outboard lowered to the lowest position. I than attempted to lift the motor up man… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Mercury Outboard: I have a 60 hp 1996 Mercury outboard. It
I have a 60 hp 1996 Mercury outboard. It has been stored inside for 3 years. Took the motor support off the other day and tied to tilt it down and am just getting a clicking noise from the module unde… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 99 mercruiser alpha one I/O 5.0. I noticed a small
I have a '99 mercruiser alpha one I/O 5.0. I noticed a small amount of greenish blue fluid under sterndrive when trailering up and heading to lake. After about 3 hours in water with no probs, I put th… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hi Tan. I have the opposite problem - the propellor leg wont
Hi Tan. I have the opposite problem - the propellor leg won't lift. We did loosen the screw and there was only a bit of hydraulic fluid in the system so maybe we need to check that. But what do we do … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1998 225 hp mercury serial # ***** 1-225422UD.The
I have a 1998 225 hp mercury serial # ***** 1-225422UD.The trim /tilt does not work from the helm or button on the side of the cowl but it does make a click-click noise like a solenoid which seems to … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
2006 F250 Yamaha having trouble with tilt upwards. Im about
2006 F250 Yamaha having trouble with tilt upwards. I'm about to install two new batteries for the season but could this be a hydraulic fluid issue?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
50 hp evinrude, 1997, outboard. last year hyd lift motor ran
50 hp evinrude, 1997, outboard. last year hyd lift motor ran well but no movement in either direction. shook the motor vertically, tried again and no problems the rest of the season. this year, same p… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1973 Evinrude Outboard. I am having problems with
I have a 1973 Evinrude Outboard. I am having problems with the hydraulic lift. The lift would work intermittent. If we tapped on it then it would work again. I took it to a boat tech and he thought it… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I just installed a new mercury 60hp4stroke EFI on my new wooden
I just installed a new mercury 60hp4stroke EFI on my new wooden runabout. Hooked the battery and tried using the tilt switch on the motor. The pump makes a noise but will not lift the motor. What am I… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1998 75 hp yamaha I believe that I need to add fluid
I have a 1998 75 hp yamaha I believe that I need to add fluid to the trim and tilt. The boat sat for about a year and had a small drip on the floor under the Trim and Tilt. The pump works but the pist… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
I have a 1987 Chris Craft 196 ltd w/a 4.3 carbed omc sterndrive.
I have a 1987 Chris Craft 196 ltd w/a 4.3 carbed omc sterndrive. Trouble began w/ replacing 50 amp fuse for trim/tilt. Worked fine for a year but this season I have intermittant t/t . I have power at … read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
i have a 1995 mercury 150 outboard on my boat. i havent used
i have a 1995 mercury 150 outboard on my boat. i havent used it in a few months and the left engine sank halfway back in the water and when i try to use the button to lift the engine it wont go up or … read more
Kenny
Kenny
Mercury & Mercruiser Diagnostics
Master's Degree
99 satisfied customers
1983 Evinrude 70EL CTE------ Tilt and Trim Issue Issue--- Motor
1983 Evinrude 70EL CTE------>>>Tilt and Trim Issue Issue--->Motor doesn't move up and down. Symptoms--->The tilt and trim motor turns on and I can hear it turning but the boat motor onl… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a outboard 2-stroke Evinrude 88 spl with power tilt.
I have a outboard 2-stroke Evinrude 88 spl with power tilt. The tilt motor worked and then stopped working. This is what I mean: The electric motor spins up, but it was taking a few seconds for the hy… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have just purchased a bass boat with a 1989 Evinrude model
I have just purchased a bass boat with a 1989 Evinrude model E50TLCEC 50 HP outboard. The problem is that the tilt/trim does not work properly. The t/t motor makes noise up and down from either pair o… read more
The Man on the Dock
The Man on the Dock
Marina Owner, Operator
Vocational, Technical or Trade Scho
74 satisfied customers
qestion Recently bought a used boat with a I/O there is inside
qestion: Recently bought a used boat with a I/O there is inside the boat on the right of the dash a button for trailer that raises and lowers the strendrive and also a trim tab on the hand throttle wh… read more
Dan Boy
Dan Boy
Amusement ride technician
High School or GED
110 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x