Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
The throttle cable on my boat was replaced in the fall of 2013. I just put the boat in the
The throttle cable on my boat was replaced in the fall of 2013. I just put the boat in the water and the throttle went up but when I tried to bring it back down it was stuck in the up position. Then I… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
have twin 470;s,,165 hp,,,just paid 2000.00 to adjust shifter
have twin 470;s,,165 hp,,,just paid 2000.00 to adjust shifter cables,,,both motors forward no problem,,,,into reverse not so much,,,port engine goes into gear at idle speed,,,soon as u apply any,throt… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
We have a johnson 40 hp outboard motor we put in a new unflex
We have a johnson 40 hp outboard motor we put in a new unflex controller side mount single lever 310 ch and new teleflex 330 cables and adapter kit. We cannot get the controller to operate correctly. … read more
Charles
Charles
Certified Mercury Tech
5,364 satisfied customers
I HAVE A 2007 VZ 225 TLR IT HAS DEVELOPED A PROBLEM WHEN I
I HAVE A 2007 VZ 225 TLR IT HAS DEVELOPED A PROBLEM WHEN I SHIFT INTO REVERSE. I HAVE TO APPLY A LOT OF FORCE TO GET THE ENGINE TO THROTTLE UP. IT SHIFTS FINE TO FORWARD AND REVERSE AND THROTTLES UP F… read more
Charles
Charles
Certified Mercury Tech
5,364 satisfied customers
I HAVE 1987 40 HP #E40ELCUD PROBLEMS WITH REMOTE CONTROL
I HAVE 1987 40 HP #E40ELCUD PROBLEMS WITH REMOTE CONTROL WAS SHIFTED FORWARD WHILE IDLE LEVER WAS UP ! IDLE COTROL HARDLY WORKS VERY LITTLE RPMS IN REVERSE FORWARD CAN OBTAIN ALMOST MAX SPEED BUT CONT… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
How do i adjist my shift cable it is shifting too hard and
How do i adjist my shift cable it is shifting too hard and might break a spline which way do i go first problem was not engaging rev i got it in reverse now but it will shift hard in foward… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 2007 VIP boat with a mercruiser 4.3 V6 carburated
I have a 2007 VIP boat with a mercruiser 4.3 V6 carburated engine and alpa 1 generation 2 . It grinds when shifting to foward or reverse. What should I check?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
i jsut purchased a 175 suzuki. standind at the helm and going
i jsut purchased a 175 suzuki. standind at the helm and going into forward it engages smooth and the throttle responds perfectly. However when you put it in reverse the it goes right into gear but has… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
my 2000 johnson 130 hp will go into reverse only when the throtle
my 2000 johnson 130 hp will go into reverse only when the throtle has been pushed way down (the rpm is about 2100).is there an adjustment of the cables to fix?… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
1988 165 alpha one removed sterndrive to replace bellows reinstalled
1988 165 alpha one removed sterndrive to replace bellows reinstalled sterndrive and now when shifting there is a chucking and grinding when shifting forward and reverse which was not there before pull… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I just dropped a 96 Evinrude OceanPro 200 on my boat. The
I just dropped a '96 Evinrude OceanPro 200 on my boat. The engine runs well, but when I launched yesterday I discovered there was no reverse. Forward works fine, and neutral is easy to find, but when … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
my throddle cable and fast idle cable is completely out of
my throddle cable and fast idle cable is completely out of adjustment. Instead of forward full throddle, i now have neutral and speed pick up in the reverse direction. my fast idle cable is adjusted a… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 125 HP Mercury that is very difficult to work the
I have a 125 HP Mercury that is very difficult to work the remote throttle on. It's goes into forward gear but is very difficult to move past the 1/2 way point and you must pull VERY hard to get it in… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
the throttle handle on my 15 hp 1996 Evinrude is stiff / tight
the throttle handle on my 15 hp 1996 Evinrude is stiff / tight , how do I adjust or lubricate this to loosen it up a little , some times its seems almost to freeze and I really need to force it , then… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
1975 50 HP Evinrude control box neutral switch has been bent
1975 50 HP Evinrude control box neutral switch has been bent slightly inside the box next to the gears and I think is keeping the control box from shifting in reverse. Does the neutral switch effect s… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 89 merc-cruiser 130 io and how do i adjust the shift
I have a 89 merc-cruiser 130 io and how do i adjust the shift cable. I can move the brass barrel on the linkage and get forward and neutral or get reverse and neutral. is my cable too streched out or … read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
i have a 1966 silverline with a 100 hp johnson golden ...
i have a 1966 silverline with a 100 hp johnson golden metoer engine and i can get all the rpms i want when i give it gas but cant get it in gear were should i start looking im not sure how te drive sy… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
i have a mercruiser 97 5.7 stern drive, boat starts great ...
i have a mercruiser 97 5.7 stern drive, boat starts great idles , when i try to put into drive engine stalls… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,277 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x