Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Mercury 50 hp outboard, runs and idles great, WOT at
Mercury 50 hp outboard, runs and idles great, WOT at 3500rpms feels like it has a governor on throttle, or something to the equivalent. … read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,555 satisfied customers
I HAVE A 40 HP Mercury 4 stroke had to put a newer lower
I HAVE A 40 HP Mercury 4 stroke had to put a newer lower unit on it the Bigfoot on it last year can not get any rpm our of it about 4000 by looking at some stuff I found it should be closer to 5500-60… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,048 satisfied customers
2006 mercury 60 hp does not run up to 6000 rpm. On average
2006 mercury 60 hp does not run up to 6000 rpm. On average around 3500 rpm. On rare occasions it will jump up to 4500-5000 for 5 to 10 seconds then shut back down to around 3000-3500. Seems like it mi… read more
Charles
Charles
Certified Mercury Tech
5,652 satisfied customers
50 hp 4 stroke Mercury after run on Little Traverse Bay,
50 hp 4 stroke Mercury after long run on Little Traverse Bay, turned motor off and used trolling motor. When started outboard noted rough engine operation. As if one cylinder was not functioning. Shut… read more
Charles
Charles
Certified Mercury Tech
5,652 satisfied customers
60 hp "2000" idles fine at first after bringing it up to
60 hp "2000 " idles fine at first after bringing it up to half to full throttle it boggs down nd dies. Hard to restart. I replaced the gas completely ( thier was water ) I replaced the fuel pump. Than… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,048 satisfied customers
I have a 50 hp 4 stroke 1998 mercury outboard,the tilt has
I have a 50 hp 4 stroke 1998 mercury outboard,the tilt has quit working(up) on both switches ,boat throttle controls and housing. Switched out relay with working engine tilt and made no difference.any… read more
Charles
Charles
Certified Mercury Tech
5,652 satisfied customers
I have a 2007 yamaha 115 hp outboard engine fuel injected.
I have a 2007 yamaha 115 hp outboard engine fuel injected. It runs great except when you hit 2,000 rpms it seems to flutter and feels like it going tostall, push back to 1900 and it s fine or go up tq… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,048 satisfied customers
My Mercury Outboard 60 HP EFI BF 2003 lost 2000RPM. Same propeller
My Mercury Outboard 60 HP EFI BF 2003 lost 2000RPM. Same propeller as when i bought the 150 Boston Whaler; 15" pitch, alu, 3 blades. I have no warning sounds. Without propeller, the engine revs up to … read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 50 hp 2006 merc. elpt efi outboard. that is only
i have a 50 hp 2006 merc. elpt efi outboard. that is only turning 4800- 5000 rpms and burning a lot of fuel. i have recently replaced the high pressure pump filter, plugs ,oil and filter, and foot oil… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,048 satisfied customers
my mercury outboard ser#0t579903 200 hp xr6 will rev up
my mercury outboard ser#0t579903 200 hp xr6 will rev up without aload but when i put it under a load it will not go over about 2500 rpm… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 16 ft. aluminum Legend fishing boat (side console).
I have a 16 ft. aluminum Legend fishing boat (side console). The hull Weight is 640 lbs. Maximum capacity is 1,220 lbs. The outboard engine is 25 HP EFI 4-Stroke. The engine's full throttle RPM range … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,048 satisfied customers
On the net there has been discussion about increasing the horsepower
On the net there has been discussion about increasing the horsepower of Mercury outboard engines by removing restrictions in the carb intakes on the same size and weight engine such as the 50hp to mak… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 15 x 48 Myacht houseboat (think of a tritoon on steriods)
I have a 15 x 48 Myacht houseboat (think of a tritoon on steriods) that weighs aprox 10,000 lbs being pushed by 2 60 hp 4 stroke Merc Bigfoot outboards. I have "reverse cup" props on them which gives … read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
This is the second time I using this service. Nothing got
This is the second time I using this service. Nothing got resolved last time, so I am going at this one more time. I own a 2007 Mercury Verado 150 hp outboard. Up until recently, it has been a power p… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I have a 2001 Mec 60 four stroke motor, It starts fine and
I have a 2001 Mec 60 four stroke motor, It starts fine and will idle without any problems. Once I get it in gear it will run good for a few minutes around 2500-3000 rpms it starts missing and will die… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
what is the fuel consumption for a honda 200 4 stroke outboard
what is the fuel consumption for a honda 200 4 stroke outboard engine running at 3800 RPM ? Thanks Chuck… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,242 satisfied customers
we have a 2004 bennington pontoon with a mercruiser 115 hp
we have a 2004 bennington pontoon with a mercruiser 115 hp efi outboard. today we notcied the tach was reading 6000 rpm (i really don't think the motor was reving @ 6000) and it ran more like a speed … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 60 hp / 4 stroke Mercury outboard thast shuts down
I have a 60 hp / 4 stroke Mercury outboard thast shuts down and sounds an alarm if you go above 30 rpm. It then shuts the motor down to an idle. What can i do?… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,242 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

21,048 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x