Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
2008 Merc 6.2 MX MPI Starboard Engine is reaching 4000 rpm
2008 Merc 6.2 MX MPI Starboard Engine is reaching 4000 rpm WOT, Port Engine is reaching 4500 WOT (close to spec). Props tuned, filters clean. Fuel Pressure at rail Schrader valve is 40psi at idle for … read more
Jason
Jason
Marine Mechanic
24,193 satisfied customers
2005 yamaha 225 4 strokes . 290 hrs . launched boat just idling
2005 yamaha 225 4 strokes . 290 hrs . launched boat just idling out of channel starboard motor died . we go anchor starts back up when give it gas then dies again . changed both fuel filter water /fue… read more
Jason
Jason
Marine Mechanic
24,193 satisfied customers
I have 1987 350/270 crusaders 1160 hrs. Im have an issue
I have 1987 350/270 crusaders 1160 hrs. I'm have an issue with my port engine, starts up fine. Idle is a little rough. Louder than the starboard. Up to 1200 RPM they both seemed the same, after that I… read more
Jason
Jason
Marine Mechanic
24,193 satisfied customers
I have a 2005 Evinrude 175 ETEC I bought used last year. I
I have a 2005 Evinrude 175 ETEC I bought used last year. I experienced one occasion last year and now multiple this year where the motor runs great and then only occasionally at lower idle speeds (22'… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
2007 225 E-Tec E225DPXSUA 05194067 Hi. My name is Charlie
2007 225 E-Tec E225DPXSUA 05194067 Hi. My name is XXXXX XXXXX you for taking time to help. Problem: Engine will only turn up 4800 rpms. Use to run 5600. Starts, idles, and runs good. Diagnose with E-T… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have twin 2009 evinrude etec 150s. Recent problem is the
I have twin 2009 evinrude etec 150's. Recent problem is the 10 amp fuse on the top of the port engine keeps blowing resulting in no ability to start or independently trim the port engine. If the engin… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
i have a 2000 200hp evinrude fitch and have just pulled the
i have a 2000 200hp evinrude fitch and have just pulled the port head off and it has melted the piston on the right hand side in two places (half moon shape). What would cause this to happen… read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
Im looking at a 1998 Stratos 2560 with twin Evinrude OceanPro
I'm looking at a 1998 Stratos 2560 with twin Evinrude OceanPro 175 FICHT engines. How do I tell if they've had the performance upgrade BRP offered?… read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
2008 Searay 290 Amberjack, 230 hours, titled in 2010 with 3
2008 Searay 290 Amberjack, 230 hours, titled in 2010 with 3 summer seasons, Mercruiser 350 MAG/MPI Bravo 3 twin engine. Stbd engine burning 20% more fuel than Port. At 3600 RPM, Stbd 15.7 gal/hr, Port… read more
Jason
Jason
Marine Mechanic
24,193 satisfied customers
I own a 2008 SeaRay 290 Amberjack with twin Mercruiser 350
I own a 2008 SeaRay 290 Amberjack with twin Mercruiser 350 MAG MPI engines. Full Tune Up each year in Spring (New Jersey) with plugs, cap, rotor. Approx 230 hrs. Fuel burn is approximately 20% higher … read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have twin crusader 1997 454 xli engines with borg v drives.
I have twin crusader 1997 454 xli engines with borg v drives. On a recent trip 2 hrs into our 3hr trip the port side engine RPMs dropped to 3000 normally cruise at 3400. Port engine no longer goes abo… read more
Ted G.
Ted G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,145 satisfied customers
I have twin mercruiser engines in my 32 boat. At idle and
I have twin mercruiser engines in my 32' boat. At idle and low rpms the engines run smoothly and seem fine. As the rpms increase to 3000 and above the starboard engine lags behind and won't make 4000 … read more
Ted G.
Ted G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,145 satisfied customers
My 2005 250HP Mercury Verado outboard port engine on my 2005
My 2005 250HP Mercury Verado outboard port engine on my 2005 Whaler Conquest 305 boat shut down while I was on a fishing trip 2 hours from home. I took off the hoses from the existing gas/water separa… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
have a 2006 90 hp etec;;;;;;;has a slight miss at low speed......totaly
have a 2006 90 hp etec;;;;;;;has a slight miss at low speed......totaly boggs down to idle speed when running at 3/4 throdle for 3 min. New plugs. ........still does the same… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 2006 E Tec 225HO with about 500 run hours on it. The
I have a 2006 E Tec 225HO with about 500 run hours on it. The engine just recently started to run ruff at idle. The engine sometime at idle just quite's. I have been running quick sliver premium plus … read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Hi I have twin 05 e-tec 250s, just bought the boat, ran great
Hi I have twin 05 e-tec 250s, just bought the boat, ran great on test drive had it shipped from cape may NJ to CT put it in the water, both motors started right up and idled for 10 mins. when I left t… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
i have a 1989 340DA sea ray with twin 7.4 carb. while out
i have a 1989 340DA sea ray with twin 7.4 carb. while out on the boat last night.. about 40 mins into the cruise heard a "bump" behind myself (starboard engine) sounded like someone closing a cabinet.… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
I have twin 2002 200 Mercury EFIs. Recently they ...
I have twin 2002 200 Mercury EFI's. Recently they began to loss RPM's. At first the port would fall from 5700 to 5200 and the starboard would fall to 5000. If I came off plane and restarted they both … read more
Pappy's Sales and Service
Pappy's Sales and Service
Marine Mechanic
Vocational, Technical or Trade Scho
852 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Marine Mechanic

4,145 satisfied customers

40 years experience, Safe boating instruct., Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,193 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

3,046 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x