Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 40 hp 3 cylinder 1999? Mercury that will run full
I have a 40 hp 3 cylinder 1999? Mercury that will run full throttle for about 30 seconds (about 5000 rpms) then cuts back to 3500 rpms. It will run at idle speed for a longer period. I pump the bulb a… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 25 hp 4 stroke mercury outboard engine that will
I have a 25 hp 4 stroke mercury outboard engine that will start but wont run at idle or lower speed, however it does run at fast speed then sputters and dies. I have emptied the gas tank and bought ne… read more
Abiorca
Abiorca
Marine Mechanic
1,824 satisfied customers
1 have a 1981 25 hp ev ele start out board. Quit running .
1 have a 1981 25 hp ev ele start out board. Quit running . Replace all lines. New fuel Pump. Gas will not leave pump . Took line of pump to carb tried to crank no gas.Motor will run if you squirt gas … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Outboard stalls after a minute or two of running. Squeezing
Outboard stalls after a minute or two of running. Squeezing primer bulb when it is about to stall keeps it running every time. compression is 121 psi in both cylinders. Float is set to spec.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 9 1/2 Hp motor (estimating age at 1973) that I use
I have a 9 1/2 Hp motor (estimating age at 1973) that I use to get my 23' Irwin sale boat in and out of my dock slip. I would like to know what the devise is that the fuel line from the fuel motor plu… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 9.9 hp old motor its not getting a steady flow of
I have a 9.9 hp old motor its not getting a steady flow of gas to the carb. checked behind fuel pump and the engine is creating suction. I put a new fuel pump on it, it didn't look the same as the one… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 9.9hp 2 stroke outboard. I had trouble starting. Initially
I have a 9.9hp 2 stroke outboard. I had trouble starting. Initially it started for about 1 minute. I then bought new gasoline, new plugs and still had the problem. I then used instant start fluid and … read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Hey Tan, i have another question. My boat has a 50 hp merc
Hey Tan, i have another question. My boat has a 50 hp merc on it. The boat will surge under throttle, if i pump the primer bulb while under full throttle it will clear up and good for 10-15 seconds. T… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hi Tan,This is a continuation of a question opened earlier
Hi Tan,This is a continuation of a question opened earlier this week. I checked the carbs when squeezing the bulb and no fuel coming into the carb. I pulled the #12 hose from the VRO pump and as soon … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
having problems keeping my outboard Evenrude 115 hp Model#E115GLEUC
having problems keeping my outboard Evenrude 115 hp Model#E115GLEUC motor running. i can get it started and it will run about a minute and then die. Using the primer bulb i can get it restared and run… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Yamaha 4 stroke: 2003 yamaha 4 stroke Motor was runnuing good.
2003 yamaha 4 stroke Motor was runnuing good. It ran about 15 mins. then shut down to idle, still runs but won't accelerate. Checked vent'\, fuel filter, gas line, power pack staying cool, it will acc… read more
Abiorca
Abiorca
Marine Mechanic
1,824 satisfied customers
2006 50 hp mercury 4 stroke. i prime the ball at the ramp engine
2006 50 hp mercury 4 stroke. i prime the ball at the ramp engine fires right up primer ball is hard working fine.i can go 5 miles or 10 doesent matter no problems. ill turn the boat engine off swim fi… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
150 Gt 89 model johnson V6. If motor sets over a day or two
150 Gt 89' model johnson V6. If motor sets over a day or two it is very hard to start, but once it cranks for the first time it can be started the rest of the day real easy. The fuel pump is pumping f… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 99 Johnson J90PLEEB. It is very hard starting and
I have a 99 Johnson J90PLEEB. It is very hard starting and primer bulb will not stay hard. I have cleaned all4 carbs. replaced all fuel lines, replaced anti-siphon valve, and new fuel pick up tube, pu… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I was just given a 7.5 hp sears gamefisher boat motor by my
I was just given a 7.5 hp sears gamefisher boat motor by my dad. He never ran it. I bought a 6 gallon tank fuel line and prime bulb. Connected everything pumped prime bulb and then...nothing! It is fi… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
1997 yamaha 80hp 2 stroke dies down at high speed, primer bulb
1997 yamaha 80hp 2 stroke dies down at high speed, primer bulb gets flat will start back up easy. Glass fuel filter empties and then fills back up sounds like fuel starved or fuel pump have been told … read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I HAVE A 25 HP MODEL E25RLEOR THINK IT IS A 1995 YEAR PROBLEN
I HAVE A 25 HP MODEL E25RLEOR THINK IT IS A 1995 YEAR PROBLEN WILL START BUT WONT STAY RUNNING HAS NEW PLUGS AND GAS . CHOKE PLUG IS HARD TO PULL OUT AND SOME GAS WILL SPRAY OUT OF FITTING AND HOSE. W… read more
Scott Martin
Scott Martin
Service manager
Vocational, Technical or Trade Scho
167 satisfied customers
1970 6o horse johnson idles alright but put it in gear and
1970 6o horse johnson idles alright but put it in gear and go it acts like it get no gas i pump the primer bulb on the tank and it takes off. i put a new fuel pump on… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x