Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 25 hp mercury 2011 EFI outboard. Sat for a few
I have a 25 hp mercury 2011 EFI outboard. Sat for a few years. I installed a new fuel pump, cleaned fuel system. Test run it ran fine for 15 minutes or so the. Stalled like its starving for fuel. It s… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
At first im sorry for my english, im from poland and i speek
Hello, at first im sorry for my english, im from poland and i speek english so and so, i have a problem with yamaha f 100 EFI (the same engine that mercury f100 EFI) it runs perfectly for some time 15… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 2001 225 Vmax that has two issues that I cant figure
I have a 2001 225 Vmax that has two issues that I can't figure out. One is that it cuts out at full throttle, and two is that it will not run over 4300 RPM. As for the first problem, when I'm running … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Have two 1999 Tamaha 200s. one just had a new power head replacement
Have two 1999 Tamaha 200's. one just had a new power head replacement After break in period, on the starboard engine, neither would turn over 3600 rpm, Both engines would appear to " load up" and stal… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have twin mercruiser 5.0 2002 engines. Gimbles/ shift cables
I have twin mercruiser 5.0 2002 engines. Gimbles/ shift cables were just replaced, engines out- prior had no problems with alarms or stalls. Now back in water and I have an intermittent 2 minute alarm… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a Mercruiser GM 5.0 (305), that is having stalling issues
I have a Mercruiser GM 5.0 (305), that is having stalling issues at high rpms. Ran it yesterday on a long trip (30 miles) and it ran fine for 35 minutes and then began to stall slightly. Slowed down, … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 50 hp Yamaha outboard F50TLRF 6C1L1017967 I installed
I have a 50 hp Yamaha outboard : F50TLRF 6C1L1017967 I installed the engine on a different boat and took it for a test drive. The engine started and ran flawlessly. I ran it for about one hour in the … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
History Intermittent starting problem. Occurred once during
History: Intermittent starting problem. Occurred once during 2010 boating season. Occurred 4 times during first half 2011 season. Boat was taken in July 2011 to certified Mercruiser mechanic who found… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
2003 496 ECM/PCM 555, port motor. The motor has an issue between
2003 496 ECM/PCM 555, port motor. The motor has an issue between 3100 - 3400 RPM. The motor will drop RPM and sputter/pop/cut out. If I push through it to 3500RPM and up it runs fine. The biggest frus… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 2003 Mercury 90 hp motor that runs fine until you
I have a 2003 Mercury 90 hp motor that runs fine until you reach 4300 to 4500 rpm's then it's like you shut the switch off but if you pull the throttle back to around 3500 rpm's it take right off and … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have Meridian 381 (2004) that has 2 Mecruiser 8.1(Gasoline).
I have Meridian 381 (2004) that has 2 Mecruiser 8.1(Gasoline). 2 weeks ago, the port engine lost RPM when it ran a couple of hours or more at high RPM(3000) on my way to San Juan island. I continue na… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
I LAUNCHED MY 2007 MONTEREY THIS WEEKEND AND MADE IT ABOUT
I LAUNCHED MY 2007 MONTEREY THIS WEEKEND AND MADE IT ABOUT 300 YARDS FROM THE DOCK AND IT STARTED SPUTTERING LIKE IT WASNT GETTING FUEL. I COULDNT EVEN IDLE BACK. GOT TOWED BACK TO MARINA (NOT VOLVO P… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Hi John, I am from Australia. I have a Volvo 8.1 litre OSi-D
Hi John, I am from Australia. I have a Volvo 8.1 litre OSi-D V8 engine it was built in the USA in 2006 late. It has a fuel pump on it a Carter Volvo number(NNN) NNN-NNNN I seem to have a low pressure … read more
John White
John White
Marine Mechanic
Vocational, Technical or Trade Scho
306 satisfied customers
I have a 315 hp yanmar engine in my 2004 Albin. Engine has
I have a 315 hp yanmar engine in my 2004 Albin. Engine has 820 hours on it. It has always been reliable until just recently. I had a day out at the canyon trolling about 8 hours. Hooked up and dropped… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
2,059 satisfied customers
Hello, I have a 1996 mercruiser V8 with a new factory 2 bbl
Hello, I have a 1996 mercruiser V8 with a new factory 2 bbl carb and my boat still was a hard time idling and has a bog or stalling condition when getting off idle. I have adjusted the carb and got it… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
Ive got a 1995 Wellcraft 5.0 Volvo Penta fuel injected boat
I've got a 1995 Wellcraft 5.0 Volvo Penta fuel injected boat that is having some problems. First, when you crank up the boat the forward, neutral, and reverse control lever goes forward all the time. … read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
403 satisfied customers
2003 115 4 stroke yamaha after fishing on a 90 degree day
2003 115 4 stroke yamaha after fishing on a 90 degree day about noon i accelrate to high speed for about 30 seconds the motor stalls. i squeeze the bulb a couple of times and it starts back for about … read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
I have a 5.0 ltr GXI with an SX stern drive, it runs great
I have a 5.0 ltr GXI with an SX stern drive, it runs great in lower RPM's and gets on step, but after a while above 4000 rpm it starts to stumble, Service guy says both fuel pumps check out fine.… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x