Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I removed my lower unit to replace the water pump kit, I
I removed my lower unit to replace the water pump kit, I left it on the side overnight and today I noticed the gear fluid was running out of the vent holes where the water goes up, where you put the e… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
My 2-stroke 90 horsepower starts fine and runs on the
My 2-stroke 90 horsepower Johnson starts fine and runs on the earmuff but when I put it in the water it won't start … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have 1996 outboard 88 HP It's pretty noisy. I was
I have 1996 Johnson outboard 88 HP It's pretty noisy. I was wondering if the exhaust has a muffler in it and if 24 years later if the baffles are worn out . Does the exhaust ever need to get changed?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Repairing water pump. I have a 1975 Mod #115593 115 hp. The
I have a 1975 Mod #115593 115 hp. The first kit I received has only one exit port and when I pulled the lower case the current and correct water pump for my model has 2 exit ports. Ordered a repair kit but they no long sell the top unit or replace ment connector tubes. Are the different pump inter changeable? Can you just let the water pump into the crankcase and then seek where it should go? … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 15 horse mod.#J15RCNC it wasn't pumping water I
I have a 15 horse mod.#J15RCNC it wasn't pumping water I changed the water pump and it is pumping the water out the holes in the case in the cavity where the pump I blew air through the copper tube in… read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
535 satisfied customers
1963 10 hp starts and runs cold. When it gets hot it will
1963 10 hp Johnson starts and runs cold. When it gets hot it will suddenly quit. Try to pull rope starter and its stuck. Wait to cools down and route will pull again. This repeats. … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 2003 Merc 9.9, 4 stroke, with carb. It has always
I have a 2003 Merc 9.9, 4 stroke, with carb. It has always run great up until now. I started it for the first time this spring yesterday. It starts right up and runs for about one minute fine and then… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a mercury 60 hp outboard and i was test running it with
I have a mercury 60 hp outboard and i was test running it with earmuffs on. Water is coming out of many ports around the lower end and out of the forward port above the lower end too. Water is also fl… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hi Jeff, I have a 1994 ish 175 Johnson V6 on a Grady White
Hi Jeff, I have a 1994 ish 175 Johnson V6 on a Grady White that I just bought from a neighbor who had not run it in several years. I cleaned all the carbs and got it running and so far it is running w… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 2006 Johnson 90 hp 2 stroke outboard. When I hooked
I have a 2006 Johnson 90 hp 2 stroke outboard. When I hooked up earmuffs to the motor this fall to winterize, I noticed I had a substantial water leak where the lower unit bolts onto the upper case al… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have 2004 johnson 115 hp and seems to have a leaking water
I have 2004 johnson 115 hp and seems to have a leaking water while pumping up to the engine. Water exhaust seems fine and the engine itself shows no sign of any water leakage. but can see leak somewhe… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have replaced water pump on my 200 Mercury Outboard Motor
I have replaced water pump on my 200 Mercury Outboard Motor and can't figure out why I am still not getting water to the upper end.… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I just bought a 1995 pontoon with an 70 horse force odutboard.
I just bought a 1995 pontoon with an 70 horse force odutboard. where do you place the earmuffs which supply the water to the engine when test firing it? And how do you know if the water pump is workin… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
have a 2003 johnson 15hp outboard 4 stroke engine water is
have a 2003 johnson 15hp outboard 4 stroke engine water is not coming out of outlet . changed impeller took air hose and blew out small tube on lower unit,long tube on upper unit and into engine via o… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
hello i have a 2003 johnson 4 stroke motor that ran great last
hello i have a 2003 johnson 4 stroke motor that ran great last year i put it in the water monday and it started up fine at first but as we pull away from the dock it started putting and that it shut d… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
I have a Mercury Marine, 9.9M (hp), 2 stroke, 1998 model, serial
I have a Mercury Marine, 9.9M (hp), 2 stroke, 1998 model, serial #0G590483, max RPM 6000. It stopped pumping water. I have removed the bottom end several times and can find nothing wrong. Impeller not… read more
Larry B.
Larry B.
Marine Mechanic
High School or GED
574 satisfied customers
hello! I am trying to remove the 6 extension on my 15 hp johnson...
hello! I am trying to remove the 6" extension on my 15 hp johnson... the shifter ( F N R) seems to be holding the lower unit in place, what do I need to do to release the shift rod from the shifter an… read more
Larry B.
Larry B.
Marine Mechanic
High School or GED
574 satisfied customers
i have a mercury 1150/115 horse /6cyl i pulled lower unit ...
i have a mercury 1150/115 horse /6cyl i pulled lower unit to replace water pump impeller i looked at the pipi and the plastic tube that fits over it the two dont seem to seal they just fit loosly toge… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x