Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Have a 1986 140 hp outboard on our boat. We were out on the
Hello- Have a 1986 Johnson 140 hp outboard on our boat. We were out on the lake today, running about 3500 RPM when the motor just suddenly lost power and shut down. When we got it home I ran a compres… read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
I have a 2000, LS 2000 twin engine jet boat that at all speeds pulls hard right and
hello, I have a 2000, LS 2000 twin engine jet boat that at all speeds pulls hard right and requires a lot of left turn input to keep it direct. Engine RPM's for both are nearly perfectly matched and s… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1998 150 hp Oceanrunner serial #G04431690--cannot
I have a 1998 Johnson 150 hp Oceanrunner serial #G04431690--cannot find model #-- looked where manual said,could not see ,boat is in water,will not run,neighbor says fuel pump(he's smart I'm not) but … read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
evinrude power trim wont go up when boats is moving. works
evinrude power trim wont go up when boats is moving. works perfectly if sitting still or out of water.… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a 2002 Johnson 150 two stroke. It seems to take forever
I have a 2002 Johnson 150 two stroke. It seems to take forever to prime with the bulb. Also has a 4 stroke troller on it and the bulb primes fine. New primer bulb on the 150. It starts hard, lots of c… read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
I am looking to buy a 1991 Lowe boat with a 70 HP Johnson motor.
I am looking to buy a 1991 Lowe boat with a 70 HP Johnson motor. Are there any particular problems that you are aware of on either of these? Any thing that is a common problem? AL… read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
I plan on circuit racing an evinrude 2011 115HO Etec. Can
I plan on circuit racing an evinrude 2011 115HO Etec. Can I buy a quickfoot or speedmaster lower unit anywhere that will fit ? And is there anything else I can do to make it faster? The boat engine cl… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
1991 mariner 40hp magnum remote steering, 1993 mariner 40hp
1991 mariner 40hp magnum remote steering, 1993 mariner 40hp magnum tiller steer both 20" shaft are these motors interchangeable.I have the remote steer and can purchase the tiller steer that is in gre… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Running high pressure [up to 150psi at 2300rpm on mechanically
Running high pressure [up to 150psi at 2300rpm on mechanically connected guage] on TAMD40B. How difficult is it to remove the filter body and disassemble and clean/replace pressure control parts? Any … read more
Expert
Expert
I have 21cc, yamaha 150 4 stroke. the steering is frozen.
I have 21'cc, yamaha 150 4 stroke. the steering is frozen. i disconnected the engine and backed off the nut securing the push rod thru the motor mount. the rod slides thru ok. however the cable does n… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I have a 1994 nitro bass boat with a 150 hp evinrude motor.
I have a 1994 nitro bass boat with a 150 hp evinrude motor. It is not charging the batteries, and I'm looking to replace whatever parts I need to in order to fix the problem. What parts would be invol… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I have a Nitro LX 700 with a Mercury/Mariner 115hp outboard
I have a Nitro LX 700 with a Mercury/Mariner 115hp outboard and my boat has severe steering torque problem. The trim tab is set as far as possible and the boat still wants to pull extremely hard to th… read more
TOM
TOM
Vocational, Technical or Trade Scho
196 satisfied customers
I have a 1976 conqueror marine jet boat powered by a 4cyl datsun
I have a 1976 conqueror marine jet boat powered by a 4cyl datsun engine. When I push the engine past 4000rpm it loses power... Any ideas on what the problem is?… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have an old Sea Sprite tri hull with a push pull cable type
I have an old Sea Sprite tri hull with a push pull cable type steeting system. It is very stiff to turn and I'm thinking I probably have to replace that cable. The motor is a 115 Evinrude outboard. Ho… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
My husband is fishing right now and wont ask for help so with
My husband is fishing right now and wont ask for help so with a little info that I have wondering if some one could give me some starters..... Just bought a 1990 Nitro bass boat with a 75 hp tracker m… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Hello again, You had it right, the tach is shot. While
Hello again, You had it right, the tach is shot. While I was running the engine today I made an attempt to turn the steering wheel. When I picked up the boat it didnt move and in the time I have had i… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Well I hope I will be able to discribe the question. I
Well I hope I will be able to discribe the question. I have a small Wellcraft 16ft, with a 90hp on it... I have notice sometimes that we I excellerate the right side (driver) of the boat is coming out… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Is there any way I can get more power out of this boat once
Is there any way I can get more power out of this boat once I get it running. It only weighs 1,100 lbs. and the fastest it has ever registered is 35 mph via GPS receiver… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x