Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 08 9.9 mercury big foot outboard on a pontoon boat.
I have a 08 9.9 mercury big foot outboard on a pontoon boat. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Mercury outboard runs great at about 3000 rpms then when
mercury outboard runs great at about 3000 rpms then when rpms are increase it slows and shuts off. New filters, new gas tank, new fuel lines and hoses. Have not drained carbs since I switched tanks. C… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,628 satisfied customers
2016 pontoon with a fuel injected 150 Mercury 4 stroke. Ran
2016 pontoon with a fuel injected 150 Mercury 4 stroke. Ran fine earlier today. This evening it won't accelerate above about 2800 rpm. It was almost out of fuel so I filled it with 93 octane. No impro… read more
Charles
Charles
Certified Mercury Tech
5,746 satisfied customers
I have a Mercury 90 HP ,2 stroke, 3 cyl. outboard. Have
Hi , I have a Mercury 90 HP ,2 stroke , 3 cyl. outboard . Have replaced fuel pump diaphragm kit , plugs , carb seals ,but motor keeps losing power . If I continue squeezing the primer bulb the motor r… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 2003 50 HP Mercury Bigfoot motor on a 20 foot
I have a 2003 50 HP Mercury Bigfoot motor on a 20 foot pontoon boat. In neutral it will rev up to 6,200 RPM and set off the alarm. It idles smoothly at 800 RPM. On the lake under load (2 people) the m… read more
Charles
Charles
Certified Mercury Tech
5,746 satisfied customers
I'm looking to buy a 2005 yamaha 200hp four stroke. During
I'm looking to buy a 2005 yamaha 200hp four stroke. During the engine survey performed by a certified yamaha mechanic, the compression results were as followed. Compression test results cyl 1-165. cyl… read more
Charles
Charles
Certified Mercury Tech
5,746 satisfied customers
2005 mercury Bigfoot 4 stroke runs sluggish at 2800 rpm with
2005 mercury Bigfoot 4 stroke runs sluggish at 2800 rpm with the rpm swinging between 2200-2800. We think it may be a fuel injection issue where too much fuel is being released to the engine. It runs … read more
Charles
Charles
Certified Mercury Tech
5,746 satisfied customers
have a mercury 90 hp 2 stroke 07 serial numbers model(NNN) NNN-NNNN
have a mercury 90 hp 2 stroke 07 serial numbers model(NNN) NNN-NNNN and 1b357679 . hard starting and smokes badly. smoke goes away at high rpm. checked compression all at 115 psi, checked choke system… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 2006 50 hp 3cyl mercury 2 stroke .I am having trouble
I have a 2006 50 hp 3cyl mercury 2 stroke .I am having trouble getting it to warm up when first started cold . currently using ngk [R] BPZ8H-N 10 SPARK PLUGS . Could you make a suggestion please . DAR… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
New 40 HP Mercury 3 cyl 4 stroke (replacing 40 HP Mariner 2
New 40 HP Mercury 3 cyl 4 stroke (replacing 40 HP Mariner 2 stroke) on pontoon. Having bad harmonic engine noise. Usually over 2800 rpm. Dealer has tried a solid hub prop ilo of the sliding hub, small… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1991,90 hp Mercury, 3cyl, that starts and runs good
I have a 1991,90 hp Mercury, 3cyl, that starts and runs good to 2800 rpm, cuts out and backfires with no more rpm's. Carbs and fuel pump been re-worked. Thanks, Thomas C. Davis [email protected]X.XXX… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I am in the market for a 90 HP Mercury outboard motor. Which
I am in the market for a 90 HP Mercury outboard motor. Which 2 stroke vs 4 stroke) is better for resale,performance and reliability. I ftroll fish a lot, but at the same time, I would like to get from… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,628 satisfied customers
I have an outboard motor. It is a 2003 Johnson 90 HP 4 stroke.
I have an outboard motor. It is a 2003 Johnson 90 HP 4 stroke. I put in fresh oil and the oil is contaminated with gas after a few hours of use. It is also bogging down at approx. 2800 RPMs.… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Hi, I have a 90hp two stroke outboard moitor when I throttle
Hi, I have a 90hp two stroke outboard moitor when I throttle up the engine initially responds and revs up at around 5000 to 6000 rpm just before the boat starts to plane the engine looses power I have… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 2001 Mercury 40 HP Fourstroke outboard motor. Motor
I have a 2001 Mercury 40 HP Fourstroke outboard motor. Motor runs poorly. It is a 3cyl. Has good spark on spark tester. Have cleaned all 3 carbs. Have not taken compression test? Motor only wants to r… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a 70 hp 2stroke 3cyl mercury 1989 bought a2002 90 hp
I have a 70 hp 2stroke 3cyl mercury 1989 bought a2002 90 hp 4 stroke is it possible to use the same controls and wiring harnass I have a panel control with the ignition key on dash. The 90 has a side … read more
Steve Sr.
Steve Sr.
No Title
High School or GED
79 satisfied customers
I have a mercury outboard, its a 50 hp. 4 stroke engine, sitting
I have a mercury outboard, it's a 50 hp. 4 stroke engine, sitting at idle the engine will attain 6000 rpms. but when I go out and put aload on it, it will only attain about 3500 to 3800 rpms and thats… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
1990 yamaha 90hp. 3cyl. #1 cylinder doesnt hit. All ...
1990 yamaha 90hp. 3cyl. #1 cylinder doesn''t hit. All carbs cleaned (twice). new plugs. compression 105, 115, and 118. Motor is in time and no double fire. All 3 cyl have strong fire and burned fuel o… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x