Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 1979 200hp mercury that won't trim down. The pump
I have a 1979 200hp mercury that won't trim down. The pump and motor works fine and I can get it to trim up just not down. Even with the the pump and all the lines disconnected I still can't get the m… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,629 satisfied customers
Need to know where water hose from water pump comes out or
need to know where water hose from water pump comes out or what it is connected to on 1995 200hp XR6 Mercury… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,629 satisfied customers
50hp merc efi bigfoot dies at full throttle and will not
50hp merc efi bigfoot dies at full throttle and will not accept fuel when pumping primer bulb … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 2003 Mercury 225 horsepower EFI, I'm trying to run
Hello, I have a 2003 Mercury 225 horsepower EFI, I'm trying to run fuel lines and oil lines and I'm confused about where they all go, where does the output from the oil pump line , go back to the fuel… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
My 2015 Verado 200 has apparently jumped into guardian mode.
Jeff, my 2015 Verado 200 has apparently jumped into guardian mode. Runs fine but won't climb over 3000 rpm. Problem began when I left key on and battery went dead. Jumped the kicker and charged big mo… read more
Charles
Charles
Certified Mercury Tech
5,747 satisfied customers
I have a 1985 Johnson 150s hp my speedometer does not work.
I have a 1985 Johnson 150s hp my speedometer does not work. How do I troubleshoot to get it to work?… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Hi, "Willie" here, I have a 2005 Mercury 200hp saltwater
Hi, "Willie" here, I have a 2005 Mercury 200hp saltwater edition and have 3 questions. 1. The motor was mouted by the previous owner to the highest position, My opinion is to drop it back to the lowes… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
my 2002 Mercury 115 HP EFI outboard motor tilted all the way
my 2002 Mercury 115 HP EFI outboard motor tilted all the way up four times while trolling and could only stop the tilting by disconnecting the battery. After a while we reconneccted the battery and th… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,629 satisfied customers
I have a 2001 22ft Key West w/1993 v6-200HP Yamaha w/25 shaft.
I have a 2001 22ft Key West w/1993 v6-200HP Yamaha w/25" shaft. Compression is 90-110. I was thinking of purchasing a used outboard, refurbished used outboard or a complete rebuilt Yamaha. What is the… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I am still workng my hard to start cold problem on my 1997
I am still workng my hard to start cold problem on my 1997 200HP EFI Merc Outboard. Based on previous Q&A I have checked the engine temp sensor and found it to be actively changing resistance with tem… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 1997 200HP EFI Mercury outboard that is hard to cold
I have a 1997 200HP EFI Mercury outboard that is hard to cold start. Runs fantastic after the engine has warmed. It is on a 1992 Ranger 391V hull. The starter has a "push to choke" feature, but becaus… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,629 satisfied customers
I have a Mercury Fuel Injected V6 2.4L XRi LASER offshore outboard
I have a Mercury Fuel Injected V6 2.4L XRi LASER offshore outboard motor on my Flightcraft Bandit hull. We bought it last yr and were told that it is a 200hp motor, but after seeing more modern 2strok… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
MY name is Randy I have a 200hp outboard mercury engine power
MY name isXXXXX have a 200hp outboard mercury engine power head and I am trying to figure out the vacum tubing lines from each cylinder to yhe reed plate ports can any one help.… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
My speedometer has quit working on my 1995 90 hp Mercury Outboard.
My speedometer has quit working on my 1995 90 hp Mercury Outboard. I suspect the hole in the pitot tube is stopped up, but I can't find the hole to clean it. I have found where the tube goes into a sm… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2010 Mercury 40 Jet 4-Stroke, it is brand new and
I have a 2010 Mercury 40 Jet 4-Stroke, it is brand new and I have not put it in the water. I bought it in mid October. The dealer said that Mercury runs the engine at the factory to test them. This is… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
My speedometer on my 135 honda outboard quit working, i am
My speedometer on my 135 honda outboard quit working, i am thinking it might be sand has plugged the tube where is it and how do i get the sand out? Thanks… read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
problem have a 2002 mercury efi 50 horsepower outboard. when
problem have a 2002 mercury efi 50 horsepower outboard. when you get rpm much above 1000 continuos audio alarm sounds. oil level is ok as well as cooling water circulation. two things i'v noticed my s… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
I have a 28 Mako with twin 2001 merury 225 optimax v6
I have a 28'' Mako with twin 2001 merury 225 optimax v6 3.0l efi''s. The starboard engine reads 7 block psi when igniton switch is in run position when engine is started i get a fault - sensor reading… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

3,847 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x