Connect one-on-one with a marine mechanic who will answer your question
Expert avatar
Dominick, Marine Mechanic
1,009 satisfied customers
25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified
Pearl avatarPearl Wilson, Assistant
Marine Mechanics are Online Now

Have boat questions? Ask a boat repair expert.

Verified marine mechanics are online around the clock and ready to answer your question online or by phone. 
Related Boat questions
My 1996 Bayliner 2855 starts backfiring and cuts out after
My 1996 Bayliner 2855 starts backfiring and cuts out after running approximately 20-30 minutes at cruise (4100 - 4200 RPM). The motor and Bravo II were replaced with brand new last year. I replaced th… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,610 satisfied customers
Why is my new 10 Mega depth and water temp not reading
why is my new 10 Mega depth and water temp not reading correct? … read more
Charles
Charles
405 satisfied customers
New 9.9 with less than 8 minutes of run time on it. I have
New 9.9 with less than 8 minutes of run time on it. I have no water coming out of pee hole. Any suggestions? … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,610 satisfied customers
90hp 4 stroke running rough at 3000 rpms and when I retu4ned
90hp 4 stroke running rough at 3000 rpms and when I retu4ned home and was flushing engine the overheat signal sounded so I shut her down? … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,610 satisfied customers
Have a cracked block. I have a 5.7 chevy with a brov2 out
I have a 5.7 chevy with a brov2 out drive need to take out the 5.7 it has a cracked block … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,329 satisfied customers
Have a 2003 Mercury 4-stroke 60hp Big foot that just started
Have a 2003 Mercury 4-stroke 60hp Big foot that just started shutting down after pushing my 18 ft. pontoon across the lake for about 30 minutes. It doesn't, it just slows down to an idle. After a whil… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,610 satisfied customers
Takes awhile to get it started, but one it does get started
Takes awhile to get it started, but one it does get started it runs fine. When I turn off and start up again, it fires right up. It's a 105 hp Chrysler from 1981 … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,329 satisfied customers
My alarm is sounding when started then when I go into gear
my alarm is sounding when started then when I go into gear it goes off … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,610 satisfied customers
F 9.9 XLHPB … WHAT DOES THIS MEAN? I have a 2006 9.9 4
I have a 2006 9.9 4 stroke I think . bought a shop manual 1995 to 2006 and nothing hardly matches the manual . not even the electrical schmatics. s/n or109075 … read more
Charles
Charles
405 satisfied customers
I've got a 9.9 outboard that won't run unless the choke is
I've got a Johnson 9.9 outboard that won't run unless the choke is applied halfway. any thoughts?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,329 satisfied customers
I have a 1979 OMC Zephyr Saildrive that needs a new ignition
I have a 1979 OMC Zephyr Saildrive that needs a new ignition switch. I have the wiring diagram for the motor and the new switch which is from Sierra. Not sure which wire goes where. Old switch was gon… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,329 satisfied customers
1989 sear ray 210 bowrider with mercruiser 350 alpha 1.
1989 sear ray 210 bowrider with mercruiser 350 cid alpha 1. Steering linkage from front single rack and pinion to back by transom. Under what looks to be the power steering assist servo. The linkage g… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,610 satisfied customers
I have a DF 140 which quit pumping water today. Upon taking
I have a DF 140 which quit pumping water today. Upon taking out the impeller it looks like the shaft has about seventy thousandths play (bearing is bad). How to replace this bearing and is it enough j… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,610 satisfied customers
I have a 2003 60hp yamaha o/ it has a miss or cyl cuts out
i have a 2003 60hp yamaha o/b it has a miss or cyl cuts out at 4k rpm this model has carbs i used seafoam fuel conditioner thinking it could be bad gas no help took out the plugs and all seemed normal… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,610 satisfied customers
I can get it started but doesn't idle. Looks like gas going
I can get it started but doesn't idle. Looks like gas going into carburetor, but doesn't want to stay running. If I get it running, then I have to play with the … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,610 satisfied customers
Trying to find out the serial and model of myhorse outboard
trying to find out the serial and model of myhorse outboard motor 1986in 50 horsepower i have some numbers but i don't know if there right … read more
Charles
Charles
405 satisfied customers
Have a 2011 ETEC 90 DSLII Tach and fuel gauge work and dont
Have a 2011 ETEC 90 DSLII Tach and fuel gauge work and dont work, example took boat out this weekend Tach and fuel gauge working , shut motor off to fish, went to restart Tach and fuel guage act like … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,610 satisfied customers
My merc outboard has an “oil reserve low” warning and alarm
My merc outboard has an “oil reserve low” warning and alarm come on, but the reserve oil tank is full. Is this a problem with the reserve in the engine itself or a faulty indicator. The engine is runn… read more
Charles
Charles
405 satisfied customers

Get help with your boat problems


Boat owners have asked the Experts hundreds of questions, such as:


  • I have a Z200TXR 2006 Yamaha 200 HPDI. It does not seem to be charging the batteries.
  • Trying to find out what type of fluid to use in the trim tilt motors Alpa 1 Gen 11.
  • I have fault codes on Volvo Penta.
  • My boat is a 4.8 Bermuda with a 50 hp Marina and I would like to have it power steer fitted. How much money is involved?

Before reaching out to an Expert on JustAnswer with your boat repair questions, be sure to have the following details prepared:


  • The make, model and year of your boat
  • The amount of use your boat has been subjected to
  • The issue at hand, including any and all symptoms
  • Any repairs you’ve attempted on your own

Consulting an Expert at JustAnswer.com can save you time, headaches and money, as early attention to a problem can prevent much more expensive repairs down the road.