BMW

BMW questions? Ask a BMW repair Expert for answers.

Connect one-on-one with {0} who will answer your question

Related BMW Questions
No crank no coms with tcm. 2008 328xi. I am. All testing was
all testing was performed with battery charger on vehicle it is not a battery issue , checked main power and chassis grounds all ok , no crank 12v to starter signal , fault codes cd99 cd9d cd9e cdb0 stored in dme , this vehicle trans went into limp mode on me than never would re start since i checked the main trans connector no sings of loose pins/corrosion, brake lights work and i tried unplugging the ibs sensor… read more
Daniel
Daniel
BMW Diagnostician
Automotive Diagnostician
908 satisfied customers
I have 2008 bwm 328xi. I have been dealing with a few
Good morning, I have 2008 bwm 328xi. I have been dealing with a few issues. For starters I found that the pin13 in the DME that controls the grounding to activate the DME had corroded off. I was getti… read more
Daniel
Daniel
BMW Diagnostician
Automotive Diagnostician
908 satisfied customers
I replaced the eccentric shaft sensor on my 2008 BMW 328xi.
I replaced the eccentric shaft sensor on my 2008 BMW 328xi. after put everything back together it crank but will not run/ … read more
Julio Quispe
Julio Quispe
182 satisfied customers
No start. 2005 bmw 645ci. Cranks but will not start. Has
Cranks but will not start. Has good fuel pressure. Good compression. Good injector power and pulse while cranking. Seems to have good power and pulse at ignition coils while cranking. But spark seems erratic at times. … read more
Julio Quispe
Julio Quispe
182 satisfied customers
I have 08 750Li, ABS module was bad, after replace with a
Hi, I have 08 750Li, ABS module was bad, after replace with a new one (not programming) the engine cranks but not start. left there for a year. and try to fix it. replaced the crank sensor. the sensor… read more
Daniel
Daniel
BMW Diagnostician
Automotive Diagnostician
908 satisfied customers
Its a 2008 mini s auto. Cranks over but not start..no
yes...cranks over but not start..no spark...crank position sensor tested good and voltage, signal and ground good...live data shows no rpm while cranking...swapped two workings sets of dme,key and cast with that both caused no crank no start.. … read more
Vatche Najarian
Vatche Najarian
Service Technician
Diploma
57 satisfied customers
My 2006 e90 325i is attempting to start and then dying, Yep,
my 2006 e90 325i is attempting to start and then dying … read more
Daniel
Daniel
BMW Diagnostician
Automotive Diagnostician
908 satisfied customers
2011 X1 E84 with N20 engine. Was having problems with the
2011 X1 E84 with N20 engine. Was having problems with the valvetronic sysyem. Found the DME was not commanding the valvetronic motor even though it has excellent power and grounds, so replaced the DME… read more
Steve
Steve
Master's Degree
25,400 satisfied customers
I need to know how to diagnose a no crank no start using
I need to know how to diagnose a no crank no start using ISTA software and possibly reset dme. To start my car died going down the road after throwing a transmission error and wouldn't turn over or cr… read more
Kenny
Kenny
Vocational, Technical or Trade Scho
1,120 satisfied customers
2007 328I was towed to me from dealership..client couldnt
2007 328I was towed to me from dealership..client couldnt afford the cost of starter replacement...so I installed a new starter and had it tested before install...scanned the car no A0B4 starter malfu… read more
Gunvir Singh
Gunvir Singh
1,949 satisfied customers
2008 bmw 328xi n51. So i was replacing the valve cover
2008 bmw 328xi n51. So i was replacing the valve cover gasket on this car and failed to follow the procedure for removing the valvetronic motor did i just completely mess up or can i still install it … read more
Steve
Steve
Master's Degree
25,400 satisfied customers
...2008 BMW 328XI Vin#wbavc93558k040628.. codes 2A16
Hello...2008 BMW 328XI Vin#wbavc93558k040628.. codes 2A16 and 2ACC.. would smoking the evap help with the first code?… read more
Steve
Steve
Master's Degree
25,400 satisfied customers
745li: I have an 02 bmw 745li 4.4 with a bad dme. Dealer wants
I have an 02 bmw 745li 4.4 with a bad dme. Dealer wants to charge me $2600 to install new one. Found used that guarantee no doa for $150. Are the keys married to dme's and ignition module? Finding so … read more
Steve
Steve
Master's Degree
25,400 satisfied customers
bmw 750li: 2006 bmw 750li has no fire at plugs and no pulse
2006 bmw 750li has no fire at plugs and no pulse at injectors. crank sensor test good. i have an engine light basic scan tool will communicate with computer and throw codes if i unplug sensors... next… read more
Kenny
Kenny
Vocational, Technical or Trade Scho
1,120 satisfied customers
X3: Hello, I have been trying to do a little research before
Hello, I have been trying to do a little research before bringing my X3 to the dealership for a service. Here is the problem I have been facing- (1) Every morning my car starts fine and stalls after a… read more
Steve
Steve
Master's Degree
25,400 satisfied customers
M3: My mechanic..cas and the car started fine..dashboard..intermittent
Hi I have a 2008 E92 M3 and have a starting problem that seems to be related to the steering lock Before getting this problem, I had the following issue - I had a low batt sign and an IBS error code s… read more
redrkt535
redrkt535
owner
Bachelor's Degree
177 satisfied customers
BMW 335i bmw 2007 335i; when we insert the key and push
bmw 2007 335i; when we insert the key and push the ignition the car will not start but all the other electrical instrument operate just fine, what could be causing the sar not to start because the com… read more
Roger
Roger
BMW Master Tech
Bmw STEP Training
3,071 satisfied customers
BMW: STALLED..AWHILE IS THERE AN EASY FIX OR HAS IT TO GO TO BMW I
I CHANGED MY ENGINE BMW E90 318D STARTED BUT STALLED ALL THE TIME BUT NOW DOES NOTHING BUT TURN OVER IS THERE SOMETHING I HAVE NOT CHANGED FROMTHE OLD ENGINE OR HAS IT GONE IN SAFE MODE AS I HAVE BEEN… read more
Roger
Roger
BMW Master Tech
Bmw STEP Training
3,071 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Roger

Roger

BMW Master Tech

3,071 satisfied customers

10 yrs. experience as BMW Master Technician, shop foreman and dealer.

Marty

Marty

ASE Certified Technician

643 satisfied customers

ASE & Bosch Certified Master Tech. Over 30 years experience.

bimmaster

bimmaster

BMW Technician

1,880 satisfied customers

3 years dealer experience, master bmw tech

Sam

Sam

BMW Master technician

1,043 satisfied customers

BMW S.T.E.P. graduate, 10 years BMW dealership experience

Thebmwbum

Thebmwbum

BMW Foreman

714 satisfied customers

31 years BMW Experience

mike

mike

BMW Technician

694 satisfied customers

bmw master tech ase certified

Matt

Matt

Engineer

486 satisfied customers

Mechanical Engineer with 20 years experience in the auto industry, 8 yrs in formula 1 engine testing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x