BMW

BMW questions? Ask a BMW repair Expert for answers.

Connect one-on-one with {0} who will answer your question

Related BMW Questions
I got a 2008 BMW 328i. I just did a valve cover job on it,
I got a 2008 BMW 328i. I just did a valve cover job on it, replaced all the gaskets and the valve cover itself cause I had a minor oil leak my gasket was cracked. … read more
MartinsMotorSport
MartinsMotorSport
Workshop Owner
Vocational, Technical or Trade Scho
88 satisfied customers
N52 leaking oil into where the spark plugs are at... as well
N52 leaking oil into where the spark plugs are at... as well there's always a bunch of oil on top of the plastic cover... is this a valve cover gasket issue or head gasket issue? … read more
VWDoc
VWDoc
Owner
Bachelor's Degree
5,666 satisfied customers
A no starting issue. So I have a bmw e39 540i One day while
So I have a bmw e39 540i One day while driving the car went over a little bump going 15 mph if that. Next the car backfired and threw a trans failsafe code, which threw the car into 4th gear. I pulled over and tried the trick of starting the car again to make the code go away because this happens every once in a while and when I start the car up after turning it off it usually gives me all my gears back. Well this time the car never started back up. I knew I had bad valve cover gaskets that were leaking onto the plugs so I thought this was causing my car not to spark. So I went and pushed it home I only drove a block away before it died on me wasn't so bad. So a week goes by and a do the whole valve cover job with new valve covers and ignition coil boots since the old boots were bad and covered in oil. Jobs all done and my first attempt to start the car after the job went south. Car did not start Checked the battery and I decided to replace the battery because the obc wasn't readying 12 volts it was under 12 and I charged the battery for 2 days. New battery in and now the car has a very slow crank and sometimes won't crank only clicks. So decided to replace crank shaft position sensor. Car still did not start. The new battery with volt meter reads 12.9 volts fully charged. Car tells me on the obc it has 12.0 Starter connections read 12.0 volts The cables leads that connect to battery while battery is connected reads 12.35 Try jumping it... nothing You can smell gas pumping from the injectors when you crank motor. So read about ground wires causing issue. Cleaned the one going to ac compresser to chassis Nothing So went around the car and sprayed the grounds with electric parts cleaner and now the car has cranking power back Car will sometimes catch just a little and back fire. … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,015 satisfied customers
My 2007 bmw 328i turned off on me and is giving me a check
Second opinion] my 2007 bmw 328i turned off on me and is giving me a check engine light and when I checked it with the machine it said it was the vanos and it was giving me a fault on a few cylinders … read more
VWDoc
VWDoc
Owner
Bachelor's Degree
5,666 satisfied customers
2009 bmw 328i. Hard to start when cold. Once the car starts
2009 bmw 328i. Hard to start when cold. Once the car starts if i shut it off and start it right away it starts perfect. But if i wait 20 min its hard to start or long crank before it starts… read more
VWDoc
VWDoc
Owner
Bachelor's Degree
5,666 satisfied customers
I have a 2009 BMW 328i that I just replaced the valve cover
I have a 2009 BMW 328i that I just replaced the valve cover seal on. The car was leaking oil previously but otherwise ran fine. I put everything back together but it is not starting i.e. it turns over… read more
adam warren
adam warren
Master auto tec
229 satisfied customers
I have an exclamation on my dash, it will crank but not
i have an exclamation mark on my dash, it will crank but not start, i recently had a crankshaft position sensor slow crank issue. i replaced the sensor and fixed that problem. i later got a cam shaft … read more
Steve
Steve
Master's Degree
24,398 satisfied customers
Oil is dripping underneath the car and when I start the car
oil is dripping underneath the car and when I start the car I can smell oil distinctly coming from the vents. There definitely seems to be a leak when I check underneath the car, but I just now notice… read more
Steve
Steve
Master's Degree
24,398 satisfied customers
My 328i BMW is not cranking after we change the valve cover
My 328i BMW is not cranking after we change the valve cover gasket and the coil packs … read more
JayPutelis
JayPutelis
Associate Degree
925 satisfied customers
After changing the valve cover gasket en my e90 328i 2008 i
hi there after changing the valve cover gasket en my e90 328i 2008 i been having many engine codes … read more
JayPutelis
JayPutelis
Associate Degree
925 satisfied customers
Code P1017. NO DTC definition found. 2007 328i sadan. I
code P1017 JA: Just to clarify, what's the exact code? And have you tried to reset it? Customer: NO DTC definition found JA: What is the model/year of your BMW? Customer: 2007 328i sadan JA: Are you f… read more
Steve
Steve
Master's Degree
24,398 satisfied customers
BMW 2008 X5 e70, replaced valve cover gasket, fuel injectors
BMW 2008 X5 e70, replaced valve cover gasket, fuel injectors professionally services and O-rings replaced. will not start. … read more
Steve
Steve
Master's Degree
24,398 satisfied customers
BMW: Im looking at purchasing either a 2008 BMW 3 Series HTDLTH
Im looking at purchasing either a 2008 BMW 3 Series HTDLTH MOON with 40,000 miles or a 2009 BMW 3 Series 328xi -63,229 miles. Can you tell me if there are any major maintenance problems you have seen … read more
JayPutelis
JayPutelis
Associate Degree
925 satisfied customers
x5: Hello,I have a 2008 BMW X5 3.0si. The car has 103,000
Hello, I have a 2008 BMW X5 3.0si. The car has 103,000 miles on it and I purchased it used around 85K miles. I recently had a "reduced power" warning and had trouble starting the car, it would crank a… read more
sprinkles08
sprinkles08
Technician
High School or GED
18,791 satisfied customers
I just replaced simple vakve cover gasket on 2007 bmw 328i
I just replaced simple vakve cover gasket on 2007 bmw 328i , everithing pluged in and clean. after repair car dont start, no comunication with modules, ind obd2 mode code P16C1. what did i break?… read more
bimmaster
bimmaster
BMW Technician
Vocational, Technical or Trade Scho
1,880 satisfied customers
328 i: Had some body work done on my car, BMW 328i. They had
Had some body work done on my car, BMW 328i. They had it for 6 weeks. When I went to pick it up, the engine stopped while idling and the mechanic ran a code for valve tropic eccentric shaft sensor fai… read more
Roger
Roger
BMW Master Tech
Bmw STEP Training
3,071 satisfied customers
2001 bmw 740il: all ive been doing is replacing parts
i have a 2001 bmw 740il..its at 94k miles now..over the pass few months all ive been doing is replacing parts, as soon as one thing was fixed another code would come up..so far ive replaced both upstr… read more
mike
mike
BMW Technician
Associate Degree
694 satisfied customers
My 2001 bmw 740il has service engine soon light. And I ...
My 2001 bmw 740il has service engine soon light. And I was told the #7 cylinder is misfiring. What are the common causes for a # XXXXX cylinder to mis fire? Thanks XXXXX: maybe this is only a coincide… read more
Roger
Roger
BMW Master Tech
Bmw STEP Training
3,071 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Roger

Roger

BMW Master Tech

3,071 satisfied customers

10 yrs. experience as BMW Master Technician, shop foreman and dealer.

Marty

Marty

ASE Certified Technician

643 satisfied customers

ASE & Bosch Certified Master Tech. Over 30 years experience.

bimmaster

bimmaster

BMW Technician

1,880 satisfied customers

3 years dealer experience, master bmw tech

Sam

Sam

BMW Master technician

1,043 satisfied customers

BMW S.T.E.P. graduate, 10 years BMW dealership experience

Thebmwbum

Thebmwbum

BMW Foreman

714 satisfied customers

31 years BMW Experience

mike

mike

BMW Technician

694 satisfied customers

bmw master tech ase certified

Matt

Matt

Engineer

486 satisfied customers

Mechanical Engineer with 20 years experience in the auto industry, 8 yrs in formula 1 engine testing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x