BMW

BMW questions? Ask a BMW repair Expert for answers.

Connect one-on-one with {0} who will answer your question

Related BMW Questions
I have a 93 325i with an M50B25TU engine. I'm about ready to
I have a 93 325i with an M50B25TU engine. I'm about ready to reassemble the engine following overhaul due to blown piston rings. The cylinders have been bored out 0.5mm, I have new pistons and rings, … read more
eric remington
eric remington
FORMER SHOP OWNER/TECHNICIAN/INSPECTOR
associates degree
1,610 satisfied customers
I have a 1989 BMW 325i and I am replacing the front crank
I have a 1989 BMW 325i and I am replacing the front crank seal and the intermediate seal, just need some info for the toque specs for the timing cover seal housing. Thanks… read more
Marty
Marty
ASE Certified Technician
Associate Degree
57,124 satisfied customers
I have a E53(02 X5) w/ M62 engine(4.4lit).. the trans 5HP24
hi , I have a E53(02 X5) w/ M62 engine(4.4lit).. the trans 5HP24 went out last yr.. ii pulled out the trans to rebuild the fwd clutch A failure. I decided to also rebuld the M62 eng. replaced everything (i.e- piston rings, rod, main bearings, heads went out repl valve seals, new head bolts, etc.. make story short. put eng in & trans. had a weak batt. re-charge batt.. went to start this morning , eng cranks but no start. it ran few sec but wont stay running. repl batt n re-attempt start. noticed the starter just clicks. noticed smoke by starter. got my 1/2 inch rachet & attempted to rotate crank. eng locked up. prior to this everything spun fine on eng stand & when I installed flywheel bolts.i also remove rocker covers to ck position of valves. also removed spark plugs to see position of pistons. didn't notice anything abvious.please help! … read more
Steve
Steve
Master's Degree
25,005 satisfied customers
My 1995 318i dash has a INFORMATION word lit up, and engine
Hi my 1995 318i dash has a INFORMATION word lit up, and engine will not start but it is cranking over with a noise like a clunk grind every revolution… read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
19,904 satisfied customers
I am working on a 2007 BMW 525i and I have 2 problems. I was
I am working on a 2007 BMW 525i and I have 2 problems. I was replacing the cam cover gasket and a front crank seal. I first found a small shaft to put in flywheel to lock it in place, thinking that th… read more
JayPutelis
JayPutelis
Associate Degree
925 satisfied customers
I am line honing a BMW m42 block. what is the spec for the
i am line honing a BMW m42 block. what is the spec for the main bore (crank) with out the bearings? cant find it in any of the books or the inter web.… read more
Thebmwbum
Thebmwbum
BMW Foreman
Vocational, Technical or Trade School
714 satisfied customers
BMW 745li: Should I buy an extended warranty $3800 3 years/
Should I buy an extended warranty $3800 3 years/ 36000 miles? Is it most likely going to save me money on repairs?… read more
Steve
Steve
Master's Degree
25,005 satisfied customers
When 2 vanos solenoids fale, is it the same as the vanos rattle
M62B35TU what sound does the engine make when 2 vanos solenoids fale, is it the same as the vanos rattle ?… read more
GEORGEBMW1
GEORGEBMW1
Auto Repair Shop Owner
Virgina Automotive Technical Instit
61 satisfied customers
Intermittent..hydraulic cam followers replaced but noise..oil pump
I have a 1996 740i(M60 engine), 200,000 miles, engine has annoying intermittent tapping noise, had hydraulic cam followers replaced but noise still there! Also replaced oil pump, flushed engine etc, a… read more
Jerry
Jerry
Service consultant
Vocational, Technical or Trade Scho
13,108 satisfied customers
2000 528i: my hub bearings (front end only)..bolts..rotor
Are there any "tricks" I need to know to change my hub bearings (front end only) for my 2000 528i BMW. I already have new replacement parts and bolts. The way I see it, I take off the wheel, take of t… read more
Chris (aka- Moose)
Chris (aka- Moose)
Vocational, Technical or Trade School
57,408 satisfied customers
Rebuild but cant separate it from the auto trans..plate..flywheel
Hi- I have a 1974 2002a. I want to pull the motor for rebuild but can't separate it from the auto trans. I have removed the plate and can see the flywheel. I see bolts through the flywheel holes I can… read more
Bill
Bill
City & Guilds
2,608 satisfied customers
95 bmw 323ic: i open drivers side door panel..power window
How do i open driver's side door panel of 95 bmw 325ic? I want to replace a motor driving power window.… read more
Cliff Burton
Cliff Burton
Master Technician / Foreman
Vocational, Technical or Trade Scho
172 satisfied customers
BMW: 260,262, 240 etc. and which vehicles they were fitted into..spec
Can you explain the difference between the BMW Getrag gearboxes ;ie 260,262, 240 etc. and which vehicles they were fitted into. Alternately, is there some form of catalog or spec chart available Thank… read more
Adam
Adam
Automotive Technician Owner 2XTechs LLC.
Associate Degree
80 satisfied customers
BMW 325: I need timing chain alignment mark..check engine light..DTC
I need timing chain alignment mark , for BMW 325 Xi and I could't find exactly TDC. So my engine run lack of power also check engine light come up , so I know timing is wrong, DTC say camshaft sensor … read more
mike
mike
BMW Technician
Associate Degree
694 satisfied customers
I own a 2000 540i BMW the engine has a knock on the right side
I own a 2000 540i BMW the engine has a knock on the right side lower rear of engine is this a major concern or is it a minor problem, also what purpose does the knock sensor serve on the v-8 BMW engin… read more
Jerry
Jerry
Service consultant
Vocational, Technical or Trade Scho
13,108 satisfied customers
2001 BMW 330i: Need to replace rear brakes and rotors
Need to replace rear brakes and rotors on 2001 BMW 330i. How difficult would this be for somewhat novice but very willing owner?… read more
RIP
RIP
Lead Technician
Vocational, Technical or Trade School
469 satisfied customers
BMW: Im replacing my valve cover gaskets..liter engine..torque specs
I'm replacing my valve cover gaskets on my BMW 4.4 liter engine. Please provide torque specs for theses covers. A spec sheet for all torque settings on this vehicle would be better.… read more
RIP
RIP
Lead Technician
Vocational, Technical or Trade School
469 satisfied customers
LOUD..CRANK SHAFT..OIL PUMP, MAINS, ROD BEARINGS AND CAM SHAFTS REVEAL
WE HAVE A 2000 740 I 4.4 BMW. THERE IS A VERY LOUD SQUALLING NOISE IN FRONT OF THE ENGINE NEAR THE CRANK SHAFT MORE TO THE RIGHT SIDE. OIL PRESSURE LIGHT FLICKERS AT IDLE INSECTION OF OIL PUMP, MAINS,… read more
Cliff Burton
Cliff Burton
Master Technician / Foreman
Vocational, Technical or Trade Scho
172 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Roger

Roger

BMW Master Tech

3,071 satisfied customers

10 yrs. experience as BMW Master Technician, shop foreman and dealer.

Marty

Marty

ASE Certified Technician

57,124 satisfied customers

ASE & Bosch Certified Master Tech. Over 30 years experience.

bimmaster

bimmaster

BMW Technician

1,880 satisfied customers

3 years dealer experience, master bmw tech

Sam

Sam

BMW Master technician

1,043 satisfied customers

BMW S.T.E.P. graduate, 10 years BMW dealership experience

Thebmwbum

Thebmwbum

BMW Foreman

714 satisfied customers

31 years BMW Experience

mike

mike

BMW Technician

694 satisfied customers

bmw master tech ase certified

Matt

Matt

Engineer

486 satisfied customers

Mechanical Engineer with 20 years experience in the auto industry, 8 yrs in formula 1 engine testing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x