BMW

BMW questions? Ask a BMW repair Expert for answers.

Connect one-on-one with {0} who will answer your question

Related BMW Questions
Its a 2008 mini s auto. Cranks over but not start..no
yes...cranks over but not start..no spark...crank position sensor tested good and voltage, signal and ground good...live data shows no rpm while cranking...swapped two workings sets of dme,key and cast with that both caused no crank no start.. … read more
Vatche Najarian
Vatche Najarian
Service Technician
Diploma
57 satisfied customers
2006 BMW X5 M54 engine. 115,000. Automatic. Wife was driving
115,000. Automatic. Wife was driving and engine just shut down. She said the dash said "Engine Failure". I changed the crank, and both cam sensors. Getting power to the crank sensor. Getting an ECM ground to the sensor as well. Fuel pressure at service port is good. Still no spark at plugs. … read more
Matt
Matt
Engineer
Bachelor's Degree
453 satisfied customers
I'm working on an 07 525i with N52 engine. I had to replace
I'm working on an 07 525i with N52 engine. I had to replace the engine due to bent valves. The engine that I installed had 119K on it. It came out of a wrecked car, so it obviously ran when it was hit… read more
Marty
Marty
ASE Certified Technician
Associate Degree
560 satisfied customers
I recently purchased a 01 bmw 330ci from auction. The car
I recently purchased a 01 bmw 330ci from auction. The car did not want to start when first attempted. pulled codes and found 3 faults in the system. crankshaft position sensor camshaft position sensor… read more
Marty
Marty
ASE Certified Technician
Associate Degree
560 satisfied customers
2000 BMW 740i M62. Ran great until low on fuel, made it to
2000 BMW 740i M62. Ran great until low on fuel, made it to the gas station before it died but was sputtering. Filled with gas, started right up, and ran great. 2 miles down the road it lost power, spu… read more
Juan Crespo
Juan Crespo
Sr. Technician
Bachelor's Degree
1,262 satisfied customers
I have a 2006 325xi with an engine misfire and multiple
I have a 2006 325xi with an engine misfire and multiple codes. Need a BMW tech to give me some advise.… read more
Steve
Steve
Master's Degree
22,908 satisfied customers
325i: My car is loosing power when I turn or up a hill
My car is loosing power when I turn or up a hill sometimes but it will idle back up and drive fine. I have pressed the gas to the floor and still low power and all of a sudden it will pick up spedd… read more
sprinkles08
sprinkles08
Technician
High School or GED
18,152 satisfied customers
325xi: Hi Guys, this is gonna be long. Chris matheson here
Hi Guys, this is gonna be long. Chris matheson here from NH, I have a 2003 325xi. I bought the car with a blown engine as a project, and to have a spare car. I replaced the motor with a used one from … read more
MartinsMotorSport
MartinsMotorSport
Workshop Manager
Vocational, Technical or Trade Scho
86 satisfied customers
this question is for bmw master tech , roger, in my shop I
this question is for bmw master tech , roger, in my shop I have a 1991 bmw 535 I with no spark or fuel pump activity , no pulse to ignition coil term 1, I do have power at dme unit pins #18,27,37 when… read more
Roger
Roger
BMW Master Tech
Bmw STEP Training
3,050 satisfied customers
injector), Can Ignite coil manually (disconnect harness from ecu..cyl
1999 Z3, Im trying to diagnose a no start (started as a miss fire yesterday, no start today), engine cranks, No Spark, No injector pulse (good 12v and ground at each coil, good 12v at injector), Can I… read more
Steve
Steve
Master's Degree
22,908 satisfied customers
BMW: vin..Running fine... no fault codes..40 mph.Engine cranks
Prefer BMW Service Technician / Dealer Service Manager experience. 2001 740iL Vin: DP30426 / 140K mi. Running fine... no fault codes present ... then engine shut off while driving @ 40 mph.Engine cran… read more
MartinsMotorSport
MartinsMotorSport
Workshop Manager
Vocational, Technical or Trade Scho
86 satisfied customers
Having trouble starting my 325xit on cold mornings
I'm having trouble starting my 325xit on cold mornings. The starter motor turns the engine until it warms enough to start. This may take 10 to 20 minutes with intermittent tries. Steve has already giv… read more
Roger
Roger
BMW Master Tech
Bmw STEP Training
3,050 satisfied customers
745i: all the suddenly quits with no spark to spark plugs..fuel rail
i have an 03 745i. the car was just working perfectly and all the suddenly quits with no spark to spark plugs. i do get gas into the fuel rail, but no spark. im getting engine light and all fuses are … read more
GEORGEBMW1
GEORGEBMW1
Auto Repair Shop Owner
Virgina Automotive Technical Instit
61 satisfied customers
323i: swap..cranks over but doesnt run i check fuel presure
I swap my engine in a 323i 2000. and now it does not run cranks over but doesnt run i check fuel presure. key on it shows 50 psi. injector signal its not there i replace cam sensor no luck. how can i … read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
19,693 satisfied customers
Bmw 318ti: 1996 cuts out at 4300 rpm..faults..knock sensor
bmw318ti 1996 cuts out at 4300 rpm, restricted power, seems like it is in limp home mode. The following faults come up just before 4300 rpm. P0325 - knock sensor 1 circuit malfunction (bank 1) p0330 -… read more
Steve
Steve
Master's Degree
22,908 satisfied customers
318i: wiring seems fine sencors are tight sencor wheels..same fault
BMW E46 318i 2003 :Car will not start fault 2872 ,wiring seems fine sencors are tight sencor wheels are tight and look fine switched the 2 sencors around makes no difference same fault although differ… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
19,693 satisfied customers
03 BMW X5 WITH 4.4 CODE 111 NO ENGINE RPM, ON SCANNER NO RPM
03 BMW X5 WITH 4.4 CODE 111 NO ENGINE RPM, ON SCANNER NO RPM ALSO NO CAM SENSOR SIGNALS. ALLDATA SAYS IF CRANK IS BAD DEFAULT WILL GO TO CAM SENSORS HOWEVER I STILL HAVE A NO START. ENGINE CRANKS OK A… read more
BrianRoger
BrianRoger
BMW Technician
Vocational, Technical or Trade Scho
19 satisfied customers
1995 525i: cranks..abs..no corrosion, spark was intermittent
1995 525i cranks but no start ! found all 3 relays and ecm, asc/abs computer under water. relays tested good under bench load, uncovered and dried ecm, found no corrosion, spark was intermittent at th… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
19,693 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Roger

Roger

BMW Master Tech

3,050 satisfied customers

10 yrs. experience as BMW Master Technician, shop foreman and dealer.

Marty

Marty

ASE Certified Technician

560 satisfied customers

ASE & Bosch Certified Master Tech. Over 30 years experience.

bimmaster

bimmaster

BMW Technician

1,838 satisfied customers

3 years dealer experience, master bmw tech

Sam

Sam

BMW Master technician

1,043 satisfied customers

BMW S.T.E.P. graduate, 10 years BMW dealership experience

Thebmwbum

Thebmwbum

BMW Foreman

714 satisfied customers

31 years BMW Experience

mike

mike

BMW Technician

694 satisfied customers

bmw master tech ase certified

Matt

Matt

Engineer

453 satisfied customers

Mechanical Engineer with 20 years experience in the auto industry, 8 yrs in formula 1 engine testing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x