We have installed a new set of brake pads, brake rotors and ...

you will need to reset the brake lining light with an instrument cluster test .

When one or more service items have been carried out, (e.g. front and rear brake linings

have been changed), these services must be reset to their full service interval.

This is accomplished using the Instrument cluster.

• To reset a service, press the reset button on the top left part of the instrument cluster

for more than ten seconds in KLR or KL15. This brings you directly to Reset mode.

A menu appears in the speedometer. At the top is the "Back" function, then the

first three service items.

The residual wear or the remaining time are specified (possibly with a minus sign).

The "!" symbol means that you can reset this service operation (early production vehicles

may show an "F"), while a "0" indicates it is not re-settable (the first 20% of the service interval

is also protected against accidental reset).

You can scroll through the service items by pressing the reset button or the lower button

(CC button) on the turn signal switch.

When you have selected a service item, press the reset button > 2 seconds to display a 2-

line menu in the tachometer.

The "Back" function is at the top, the re-settable service item is below it. Now select the

service item with the reset button (or the CC button) and press and hold the reset button

again.

In a third menu line, further down, the system confirms that the reset volume was successful.

The whole interval for the service operation is shown in the "Service Need Indicator " using

the Control Display.

give this a shot and let me know how it works out for you .