How do you reset the key barrel system in my 95 xr6?

<p>there are a few methods depending on model try this and if it dosent work i give you another way </p><p> </p><p># XXXXX The ignition switch should be in the Off position, with all the<br />doors shut and Unlocked.<br /># XXXXX Turn the ignition key to the ACCESSORY position and within 5<br />seconds, operates the rear demister switch exactly three times in quick<br />succession. (IE. Press the switch so the Demister light turns on, then<br />off, then back on again.)<br /># XXXXX After the 5 seconds is up, the door locks will change state, to<br />indicate that the BEM has entered keypad learn mode.<br />NOTE : All existing keypads at this point, have been erased from memory<br />!<br /># XXXXX Press either buttons on the keypad that is to be trained. The door<br />locks will change state twice, to indicate that the keypad has been<br />added to the BEM memory.<br /># XXXXX Follow step 4. for each keypad that is to be added to the BEM<br />memory. A maximum of 4 keypads can be added to the BEM memory.NOTE :<br />You must teach all remote keypads for the Smartlock module, before<br />proceeding.<br /># XXXXX When you have taught all the remote keypads, turn the ignition to<br />the Off position to leave the learn mode. The door locks will change<br />state to indicate a return to normal mode.<br /># XXXXX Check the function of both buttons on each keypad, to ensure that<br />the keypad has been trained.</p><p> </p><p>ps keep the window down just incase..</p>

Hi.
You need to do a smartlock relearn to download the codes from the new barrel into the smartlock module. Procedure is as follows:

Smart lock relearn procedure
When changing a Smart lock module (or barrel) you will need to download the electronic lock assembly codes before you can start the car, to do this use the following procedure.
•     Make sure ignition key is off and connect replacement smart lock module.
•     With the ignition turned to the off position, the warning jewel (red LED on dash) will flash the armed code (short flash with longer pause)
•     Turn the ignition to the run position and leave there. (After a short time the warning jewel will flash rapidly.
•     After 30 minutes (or 61 minutes for AU1), the door locks will change state twice and the warning jewel will go out.
•     Turn the ignition off for at least 30 seconds, until the warning jewel displays the armed code.
•     Verify the system by starting the engine.
•     On AU2/3 vehicles which use Smart Shield it is necessary to use a scan tool to link the keys to the B.E.M. (both keys are required to do this) and also to link the B.E.M. to the P.C.M.


Hope this helps.

Matt.