The flame starter on my range top is clicking but I didn't…

I will need a valid model number to pull up parts and diagrams.

In general, does the clicking stop once you turn all stove top burners on?

I will need a valid model number to pull up parts and diagrams.

In general, does the clicking stop once you turn all stove top burners on?

Ok, this would have to be an issue with the spark module. See this image for locations to check for the model tag. I will need a model number to look up the part if you intend to repair this yourself. If not I can get you a phone number to schedule in home service if you choose.

Thanks, ***** ***** a moment to look this up

Ok, you may have a different issue going on because this machine is much simpler than I was expecting. From this wiring diagram, the spark module cannot get power unless one of the ignition switched beneath the knob is closed. Do you have to push down on your knobs to engage spark? If yes you have a failed switch instead.

Yes, per the manual you should have to push the knob down slightly to begin ignition. I went ahead and reviewed the manual while I was at it. Give me a moment to gather information for the ignition switch

This is the ignition switch for this model https://partsdr.com/part/7403p367-60-burner-switch

The only thing is that all burners must be unscrewed from the top in order to replace the switch. The burners if they are seized and cannot be removed due to failing screws, you will need to contact a technician for a drill out and replacement of other gas related parts to salvage this machine. That may not be very cost efficient. But if the burners come off easily, you can then test each switch for continuity. They should have no continuity when the switches are in the off position. Which ever switch reads closed* when the valve is turned off would be the one that needs to be replaced.

Only other alternative to this is to unplug the machine and use a candle lighter to light the flame and discontinue use of the spark ignition, the machine will still work this way.

Which ever switch reads closed when the burner is off, not open. I had a typo above

Yes you can call 1-***-***-**** to request in home service, they will dispatch your information to a servicer near you. Once that servicer has your information, they will contact you to schedule a visit. That is the customer service line for Whirlpool, they own Maytag

No, that number is ***** they can take your information then dispatch it to a preferred servicer nearest you