Appliance

Need appliance repair help? Ask a technician for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Appliance Questions
We have a Maytag washer. Model Epic Z 600. It is front
It is front loading about 10 years old. The door is locked and can't open. The clock showed 3H and could be adjusted but could not be reset to "blank" It was unplugged, left unplugged, then replugged, but still won't operate. For the past few days when it was operating, during the wash cycle there was a "bumping" type noise, like it might have been unbalanced, but the loads were quite small. Also, during the wash cycle. the clock stayed frozen at number 14. I thought the clock showed minutes. Is that correct, or is it just a number in the cycle? Also, the clock styays on number 1 for a period longer than l minute when the spin cycle is ov er before you could access the load, that is when the door would be able to be opened. Is this a mechanical problem, an electrical problem, and is it repairable for minimal cost? Or should we just look for a new washer? … read more
Melissa Martin
Melissa Martin
Senior Technician
Whirlpool , Frigidaire, Maytag, GE, LG Authorized
712 satisfied customers
Have a 10 year old Maytag epic Z washer. I have a 10 year
I have a 10 year old maytag epic Z front load washer.model mhwz400tq02.The wash cycle always works correctly.the rinse cycle sometimes stops at the beginning and sometimes at the end, the spin cycle also stops at the beg. or end. I can finish the load by selecting rinse and spin, or if it makes it that far the spin cycle. sometime it takes more than one attempt. Is it the electronic control at the top right of the washer. the filter by the pump is clear … read more
Kelly
Kelly
Appliance Technician
High School or GED
26,364 satisfied customers
I have an epic z washer. The filter and drain have been cleaned
I have an epic z washer. The filter and drain have been cleaned and the pump has been replaced. It won't complete a cycle. Tried doing a rinse and spin and it fires up and starts working but then will… read more
Master Tech
Master Tech
Vocational, Technical or Trade Scho
22,368 satisfied customers
Maytag Epic Z frontloading washer. I put in a normal load of
Maytag Epic Z frontloading washer. I put in a normal load of clothes and start the cycle. It gets to the beginning of the spin cycle and just shuts off. It doesnt lock the door but the clothes are sti… read more
Tyler Z.
Tyler Z.
Home Appliance Technician
Bachelor's Degree
110,489 satisfied customers
I have an older Maytag washer, model LAT 5000 ABV, it works
I have an older Maytag washer, model LAT 5000 ABV, it works through the cycle, but won't pump the water out… read more
John
John
Home Appliance Technician
Vocational, Technical or Trade Scho
13,453 satisfied customers
i have a maytag Epic Z front load washer MHWZ 600TW01 that
i have a maytag Epic Z front load washer MHWZ 600TW01 that keeps getting an F33 error code. the book says to check the wiring harness connections from the pump to the central control unit. Not sure ho… read more
gst85
gst85
Appliance Tech
3,969 satisfied customers
I have Kenmore Elite HE3 model 49962 front load washer that
I have Kenmore Elite HE3 model 49962 front load washer that has stopped spinning... it goes through the rest of cycle fine, just doesn't spin when it should spin... ran diagnostic and got nothing ... … read more
Tyler Z.
Tyler Z.
Home Appliance Technician
Bachelor's Degree
110,489 satisfied customers
I have an Epic Z washer. My daughter put in a small load of
I have an Epic Z washer. My daughter put in a small load of laundry and accidentally got a bit of the clothing stuck in the door. I think it must have caught on the closure mechanism as she put the cl… read more
Tyler Z.
Tyler Z.
Home Appliance Technician
Bachelor's Degree
110,489 satisfied customers
My Epic Z Washer sounds like a 747 taking off when it is in
My Epic Z Washer sounds like a 747 taking off when it is in the spin cycle. Any ideas whats going on? And is it a easy fix?… read more
Appliance Tech Dave
Appliance Tech Dave
Vocational, Technical or Trade Scho
4,021 satisfied customers
I recently purchased a Maytag Epic-z. It is 1-year-old and
I recently purchased a Maytag Epic-z. It is 1-year-old and was repossed. They company delivered and set it up for me and showed me how to run it. I have done 3 loads of clothes and each time I have ha… read more
John
John
Home Appliance Technician
Vocational, Technical or Trade Scho
13,453 satisfied customers
Trying to repair Maytag Performa top loading washer. No agitation
Trying to repair Maytag Performa top loading washer. No agitation and the drum won't spin. Motor makes a sound like it is binding and I can smell something like burning rubber then the motor shuts off… read more
esequiel walker
esequiel walker
Appliance technician
High School or GED
4,647 satisfied customers
I am trying to repair a Maytag top loading washetr. It was
I am trying to repair a Maytag top loading washetr. It was recently installed in a basement where it must drain 6 feet up, and didn't fully drain the first time I ran a load there. I replaced the belt… read more
Tyler Z.
Tyler Z.
Home Appliance Technician
Bachelor's Degree
110,489 satisfied customers
Our Maytag Epic Z (MHWZ400TQ01) which weve only had for about
Our Maytag Epic Z (MHWZ400TQ01) which we've only had for about 2 years, will not work. The door lock light keeps coming on and the washer will not drain at all. I put a load of clothes in and the mach… read more
The Home Smithy
The Home Smithy
Home Appliance Technician
Vocational, Technical or Trade School
6,152 satisfied customers
I have an Epic Z washing machine. Today, it is not spinning
I have an Epic Z washing machine. Today, it is not spinning at all. Is there anything I should try?… read more
Bob L Your  Appl Pal
Bob L Your Appl Pal
Owner
Vocational, Technical or Trade Scho
7,404 satisfied customers
Sears Kenmore washing machine Series 70 Heavy Duty - will wash
Sears Kenmore washing machine Series 70 Heavy Duty - will wash fine but on final rinse will leave clothes wet and water in drum. If run through a second spin cycle will get most of water out but still… read more
Tyler Z.
Tyler Z.
Home Appliance Technician
Bachelor's Degree
110,489 satisfied customers
We have a Maytag Epic Z washer that vibrates terribly when
We have a Maytag Epic Z washer that vibrates terribly when in use either high or low setting. The Unit is level all around is there something missed by the installer that needs to be done to rectify t… read more
Tyler Z.
Tyler Z.
Home Appliance Technician
Bachelor's Degree
110,489 satisfied customers
Maytag Epic Z - Type 832 front load washer. On spin cycle,
Maytag Epic Z - Type 832 front load washer. On spin cycle, machine becomes very loud and jumpy. What can I do? Thanks. Tim… read more
Master Tech
Master Tech
Vocational, Technical or Trade Scho
22,368 satisfied customers
I recently purchased a Maytag Epic Z Front Loader washer and
I recently purchased a Maytag Epic Z Front Loader washer and there is about a 1/4" of water that is left in the area where the laundry softner is to be added, after I do a load of wash. Is there somet… read more
John
John
Home Appliance Technician
Vocational, Technical or Trade Scho
13,453 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Thank you for the expeditious answer. It's good to know you're out there and awake in the wee hours when I finally have time to ask questions about my Jenn Air.

JeanRiverhead, NY

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

< Previous | Next >

Meet the Experts:

John

John

Home Appliance Technician

13,453 satisfied customers

Appliance repair business owner for over 43 years.

Tom Goellner

Tom Goellner

Home Appliance Technician

1,954 satisfied customers

32 yrs. experience servicing major appliances and HVAC equipment.

Tyler Z.

Tyler Z.

Home Appliance Technician

110,489 satisfied customers

11+ years being an appliance technician with factory training.

Kelly

Kelly

Appliance Technician

26,364 satisfied customers

Highly accurate diagnostician with over 30 years experience!

The Home Smithy

The Home Smithy

Home Appliance Technician

6,152 satisfied customers

30 years repairing appliances

william

william

Home Appliance Technician

3,018 satisfied customers

Major Home Appliance Technician Specialist Whirpool Certificate

RUSS

RUSS

SERVICE TECHNICIAN

1,830 satisfied customers

TECHNICIAN AND TEACHER

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x