Appliance

Need appliance repair help? Ask a technician for answers ASAP

Ask an Expert,
Get an Answer ASAP!

My centennial MCT is showing codes "blinking Sensing & wash"

Customer Question
My centennial MCT is...

My centennial MCT is showing codes "blinking Sensing & wash" at same time, then Done blinks. Goes back & forth. Problem I am having is it is not draining & spinning at end of load.

Contractor's Assistant: What's the make and model of your washing machine? And can you guesstimate how old it is?

I don't have paperwork in front of me, but I bought about 2 years ago

Contractor's Assistant: Do you plan on doing the work yourself?

If possible. Model # is MVWC415EW0

Contractor's Assistant: Anything else we should know to help you best?

Just need to know how to fix. I ran diagnostic & it ran thru each cycle.

Submitted: 6 months ago.Category: Appliance
Show More
Show Less
Ask Your Own Appliance Question
Answered in 2 hours by:
12/27/2017
Appliance Technician: Appliance Tech Dave, Home Appliance Technician replied 6 months ago
Appliance Tech Dave
Appliance Tech Dave, Home Appliance Technician
Category: Appliance
Satisfied Customers: 2,915
Experience: 30 years experience specializing in Whirlpool, KitchenAid and Kenmore
Verified

Hello, this is Dave and I welcome you to JustAnswer. I'm reviewing your question now, and will post back with your reply ASAP.

Ask Your Own Appliance Question
Appliance Technician: Appliance Tech Dave, Home Appliance Technician replied 6 months ago

The code means that there was no fill or it took too long to fill. Make sure both hot and cold are turned on. If they are see if you are getting both cold and hot into the wash. Let me know what you find.

Ask Your Own Appliance Question
Customer reply replied 6 months ago
We are on a water well, so will check connections & see if any calcium buildup. Clear all water lines, and try again. Won't be until tomorrow. Will this ticket stay open for a couple of days. Don't want to have to pay again if this does not solve the problem.
Appliance Technician: Appliance Tech Dave, Home Appliance Technician replied 6 months ago

Sure, no problem, it will still be available and I can send a reminder in a few days to see how it goes. The cold side in the valve will often be where you find sediment from the well. Clean it but don't try to pull out the screen or it will get damaged.

Ask Your Own Appliance Question
Appliance Technician: Appliance Tech Dave, Home Appliance Technician replied 6 months ago

Do you have an update on what you found? Do you still need help?

Ask Your Own Appliance Question
Was this answer helpful?

How JustAnswer works

step-image
Describe your issueThe assistant will guide you
step-image
Chat 1:1 with an appliance technicianLicensed Experts are available 24/7
step-image
100% satisfaction guaranteeGet all the answers you need
Ask Appliance Tech Dave Your Own Question
Appliance Tech Dave
Appliance Tech Dave
Appliance Tech Dave, Home Appliance Technician
Category: Appliance
Satisfied Customers: 2,915
2,915 Satisfied Customers
Experience: 30 years experience specializing in Whirlpool, KitchenAid and Kenmore

Appliance Tech Dave is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Thank you for the expeditious answer. It's good to know you're out there and awake in the wee hours when I finally have time to ask questions about my Jenn Air.

JeanRiverhead, NY

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

< Previous | Next >

Meet the Experts:

John

John

Home Appliance Technician

13,453 satisfied customers

Appliance repair business owner for over 43 years.

Tom Goellner

Tom Goellner

Home Appliance Technician

1,602 satisfied customers

32 yrs. experience servicing major appliances and HVAC equipment.

Tyler Z.

Tyler Z.

Appliance Doc

87,701 satisfied customers

9+ years being an appliance technician with factory training.

Kelly

Kelly

Appliance Technician

20,213 satisfied customers

Highly accurate diagnostician with over 30 years experience!

The Home Smithy

The Home Smithy

Home Appliance Technician

6,148 satisfied customers

30 years repairing appliances

william

william

Home Appliance Technician

3,012 satisfied customers

Major Home Appliance Technician Specialist Whirpool Certificate

John

John

restaurant equipment technician

2,103 satisfied customers

25+ years experience. I'm now employed by a commercial cooking equipment service company

< Previous | Next >

Related Appliance Questions
Washer: just did diagnostic modd on maytag centennial lights
washer: Hi just did diagnostic modd on maytag centennial lights are blinking what's next … read more
Tyler Z.
Tyler Z.
Appliance Doc
Bachelor's Degree
87,701 satisfied customers
My washing machine is a maytag centennial and it started
my washing machine is a maytag centennial and it started having issues during rinse and spin cycle … read more
Webb-Guy
Webb-Guy
Maitenance Supervisor
Associate Degree
3,203 satisfied customers
Maytag Centennial Washer almost 5 years old. Doesn't execute
Maytag Centennial Washer almost 5 years old. Doesn't execute rinse and drain cycle properly from any type of wash. Have to stop the machine and go direct to the drain and spin to complete? Suggestions… read more
Nolan Rettig
Nolan Rettig
Service Technician
High School or GED
326 satisfied customers
Trouble shooting a whirlpool wtw5500xw1 washer with a lid
trouble shooting a whirlpool wtw5500xw1 washer with a lid lock issue. … read more
HVAC Guru
HVAC Guru
Service Technician
Associate Degree
682 satisfied customers
I have done the diagnostic cycle and it seems like only 1
I have done the diagnostic cycle and it seems like only 1 code is coming up. It is causing the sensing light rinse spin and done to flash then just the done light … read more
Tyler Z.
Tyler Z.
Appliance Doc
Bachelor's Degree
87,701 satisfied customers
Appliance: Maytag Centennial Washing Machine Model #:
Appliance: Maytag Centennial Washing Machine Model #: MVWC415EW1 Issue: Stops after “wash” cycle. Doesn't drain (didn't use detergent in this test wash so no suds present) Ran Diagnostic Test. It went… read more
Tyler Z.
Tyler Z.
Appliance Doc
Bachelor's Degree
87,701 satisfied customers
Maytag Centennial washer. Quit mid cycle...small load of
Maytag Centennial washer. Quit mid cycle...small load of towels, drained but did not spin. Unplugged for about 5 minutes to reboot and start wash cycle over lid locks, green sensor comes on, then red … read more
Don T.
Don T.
President
Associate Degree
179 satisfied customers
We just heard from our daughter's rental home. A Maytag
We just heard from our daughter's rental home. A Maytag Centennial model MVWC300VW0 stopped in midcycle with a load of wash and filled with water. I am not familiar with the washer. … read more
Webb-Guy
Webb-Guy
Maitenance Supervisor
Associate Degree
3,203 satisfied customers
This is. I have a Maytag Centennial won't rinse or spin or
Customer: Hi ***** ***** this is tony. I have a Maytag Centennial won't rinse or spin or do much else ran diagnostic test and codes came back as sensing+rinse+spin+done and rinse+done … read more
Tyler Z.
Tyler Z.
Appliance Doc
Bachelor's Degree
87,701 satisfied customers
Washer mod.wfc7500wv2 dianaustic test shows ok but washer ends
washer mod.wfc7500wv2 dianaustic test shows ok but washer ends cycle before spin out at about 5min run through sensing then ends cycle… read more
Whrlp Master Tech
Whrlp Master Tech
Vocational, Technical or Trade Scho
4,977 satisfied customers
I have a maytag centennial model MVWC425BW0. Everything works
I have a maytag centennial model MVWC425BW0. Everything works up until the end of the spin cycle. At the very end of the spin cycle it starts the entire wash cycle over. If I don't catch it the machin… read more
Appliance Tech Dave
Appliance Tech Dave
Home Appliance Technician
2,915 satisfied customers
Can you help me with model mvwc360aw0? it seems that it wont
Can you help me with model mvwc360aw0? it seems that it wont spin out. it pumps water out of it, but doesn't seem to be spinning. when its finished , the lid unlocks, "wash" light stays lit. I have re… read more
Whrlp Master Tech
Whrlp Master Tech
Vocational, Technical or Trade Scho
4,977 satisfied customers
I have a Maytag Centennial MVWC400XW3. The machine seems to
I have a Maytag Centennial MVWC400XW3. The machine seems to have stopped spinning. The lid lock flashes when I start any of the cycles. I was able to access the diagnostic mode by starting at Regular … read more
Appliance Tech Dave
Appliance Tech Dave
Home Appliance Technician
2,915 satisfied customers
After running the diagnostics I get the following flashing
After running the diagnostics I get the following flashing lights. Fill - Rinse - Done Then Spin Done I have the model WTW4800XQ2 and it will not spin. Everything else seems to work fine. It will fill… read more
Whrlp Master Tech
Whrlp Master Tech
Vocational, Technical or Trade Scho
4,977 satisfied customers
My maytag centennial washer, model # XXXXX stops on the
My maytag centennial washer, model # XXXXX stops on the wash cycle. When we start the washer it will fill with water but when we come back and check it the green light under wash is on but the washer … read more
Appliance Tech Dave
Appliance Tech Dave
Home Appliance Technician
2,915 satisfied customers
Hi, Jon. Ive got a GE front-load washer not finishing a cycle. GE
Hi, Jon. I've got a GE front-load washer not finishing a cycle. GE GFWN1000L - the water valves are showing continuity - the system does fill and drain, and spin, before shutting down unfinished - the… read more
Tyler Z.
Tyler Z.
Appliance Doc
Bachelor's Degree
87,701 satisfied customers
I replaced the board on the Whirlpool Caprio washer and it
I replaced the board on the Whirlpool Caprio washer and it still won't spin. Model WTW5600XWO serial C10230116, what next?… read more
Appliance Tech Larry
Appliance Tech Larry
Outside inhome service tech
High School or GED
19,156 satisfied customers
Kenmore front load washer 417.44102300 seems to wash ok
Kenmore front load washer 417.44102300 seems ??? to wash ok wont spin dry at end just goes into wash mode? turn clock wise then counter clock wise ran from the last setting empty it did spin has done … read more
Tyler Z.
Tyler Z.
Appliance Doc
Bachelor's Degree
87,701 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x