How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel Your Own Question
Daniel
Daniel, Home Appliance Technician
Category: Appliance
Satisfied Customers: 16543
Experience:  20+ yrs. experience in appliance repair. NVQ Level 2 electronics manufacturers training courses in England.
15468697
Type Your Appliance Question Here...
Daniel is online now
A new question is answered every 9 seconds

Ariston washer dryer combo Model: AWD121 The cloths come out

Customer Question

Ariston washer dryer combo
Model: AWD121The cloths come out damp, I replaced the NTC sensor and still same problemThanks
Submitted: 5 months ago.
Category: Appliance
Expert:  Daniel replied 5 months ago.

Hi, I'm Daniel welcome to JustAnswer, Im reviewing your question now and will post back with your reply momentarily

Expert:  Daniel replied 5 months ago.

Are you getting any flashing lights from the washer?

If so which lights are flashing?

Customer: replied 5 months ago.
Hi Daniel I have to check and get back to you
Expert:  Daniel replied 5 months ago.

No worries,

Customer: replied 5 months ago.
Nothing flashes it will finish the cycle but the cloths come out damp
Expert:  Daniel replied 5 months ago.

Ok stupid question but this washer has a speed selector dial on the front.

Is this set to a faster spin?

Customer: replied 5 months ago.
No just normal spin, could it be something clogged?
Expert:  Daniel replied 5 months ago.

Ok if its going through the cycle ok and its doing the normal spin then its possibley clogged in there.

This model has a front filter. Remove the plastic trim on the front at the bottom and you will see the filter on the right hand side. Check this to see if its blocked up in there.

Also check the waste hose as well and see if theres blocked in there.

Customer: replied 5 months ago.
The front filter I already cleared is there a lint trap in this combo unit?
Expert:  Daniel replied 5 months ago.

Theres a sump hose under there which can block up.

If you access the underside of the washer there you will see a black hose going from the tub to the pump.

Remove the hose from there and check to see if theres anything blocked in there.

Customer: replied 5 months ago.
Ok i will try and get back to you
Expert:  Daniel replied 5 months ago.

No worries thats fine.

Customer: replied 5 months ago.
Ok so what I did is I opened the heater cover from the top and cleaned a lot of lint, and it's working good now
Expert:  Daniel replied 5 months ago.

Ok so its the dryer side you was having trouble with was it?

From your question i thought it was the spining you was having trouble with as i thought you ment it was comming out wetter then it should after its spun.

If it was the dryer side not working then a blockage in the heater box will cause this fault.