How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Barry G. Your Own Question
Barry G.
Barry G., Home Appliance Technician
Category: Appliance
Satisfied Customers: 6823
Experience:  27 years in home appliance repair. EPA refrigerant transition and recovery certification type I & II.
Type Your Appliance Question Here...
Barry G. is online now
A new question is answered every 9 seconds

maytag refrigerator, Model # XXXXX 2568 AES compressor motor

This answer was rated:

maytag refrigerator, Model # XXXXX 2568 AES compressor motor comes on makes led's on front control panel blink (ice and water do not work) and ice cube door opens and closed till motor cycles off.
Hello my name is XXXXX XXXXX you for choosing our service. If you find my answer satisfactory please login if you are not already logged in and leave an ok or better rating.

You need to replace the high voltage board arrowed in the diagram below that is under the cover on the back of the refrigerator. I recommend you leave the ice maker off, empty the ice bin and turn the water supply off to the unit just in case it decides to do something unexpected and of at all possible disconnect the power cord from the wall outlet to keep from damaging other parts.

I have not included a part number for this model on purpose. Do not order this part online. Only order this part in person and take your model number along with the serial number to get the main control board. Make the clerk aware that this is a model in a series that was made in which the model number will be 2 different boards and to use the serial number to double check you are getting the correct part.This is very important, even in person its not easy to get the correct board if the clerk is not aware of or run into it before, and ordering this part online can be a nightmare.

Follow the instruction sheet that comes with the board to program the board with the code on your model and serial sticker inside the refrigerator. The numbers of the code will be right after the word code.

To change the board remove the 4 hex screws holding the high voltage cover on or the snap on cover whichever yours has.

Remove the plastic lid by prying it out from the right side of the box.

Disconnect the harness connections from the board.

Unclip the board from the retainers.

Be sure to return wires to the wire slots on the panel bottom of the control box.

Reverse to reassemble.
That will take care of it, if you have questions please ask.

Barry G. and 4 other Appliance Specialists are ready to help you