How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Alan Your Own Question
Alan, Home Appliance Technician
Category: Appliance
Satisfied Customers: 273
Experience:  20+ years in the appliance repair field.
Type Your Appliance Question Here...
Alan is online now
A new question is answered every 9 seconds

I have replaced the Control Board on my Frigidaire GLTF2940ES3

This answer was rated:

I have replaced the Control Board on my Frigidaire GLTF2940ES3 washer. I am still getting the same original error code of: E23
My name is XXXXX XXXXX I will be helping you today. Please remember, I do not get paid for my time and expertise until you accept.[/]
Thank you for using JustAnswer. Does your machine drain the water out?
Customer: replied 5 years ago.
NO it does not drain or spin
When it is in the spin cycle, does it rotate back and forth slowly?
Customer: replied 5 years ago.

NO the SPIN speed indicator lights switch to the NO SPIN and the tub does not move

The first thing I would do is check your drain pump to make sure it is not plugged. If that is ok then the door lock assembly could be bad. Frigidaire had some problems with these switches doing strange things.
Alan and other Appliance Specialists are ready to help you
Hi [Customer Name],

I'm just following up with you to see how everything is going. Did my answer help?

Let me know,
[Expert Name]
Customer: replied 5 years ago.
I remove the drain pump assembly and tried to test run it on the bench and it would not run. I found a broken wire in the windings. I purchased a new pump and installed it. Everything is warking fine now. THANKS