How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Bryan Your Own Question
Bryan
Bryan, Home Appliance Technician
Category: Appliance
Satisfied Customers: 12156
Experience:  15 yrs. experience as a certified appliance technician.
10522817
Type Your Appliance Question Here...
Bryan is online now
A new question is answered every 9 seconds

The washer completes all its cycles but leaves clothes sopping

This answer was rated:

The washer completes all it's cycles but leaves clothes sopping wet after the spin cycle. There is still some water in the tub that doesn't get fully drained out. Pump works well when it is on, with a heavy stream of waste water to the drain (rules out obstructions) but something is going on with the water level sensor or other component.
Hi,Welcome to Just Answer, My name is XXXXX XXXXX forward to helping you today.

is the door locking and this going into high speed spin ?
Customer: replied 5 years ago.
Yes, door lock works properly during spin cycle.
well there are only two reasons for this issue, 1 the washer is allowing water into the machine as it spins which means the fill valve is not closing tightly and water is getting in, or 2 the pump may seems like it pumping correctly but probably isn't. the drain cycle is timed and if the water isn't draining fast enough while the pump is on theres not enough water extracted before the end of the spin cycle. try turning the water off while this is in a spin cycle and see if that does it. if so change the water valve if not change the pump. assuming this is spinning up to speed like you say.
Bryan and 2 other Appliance Specialists are ready to help you