How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tyler Z. Your Own Question
Tyler Z.
Tyler Z., Appliance Doc
Category: Appliance
Satisfied Customers: 81203
Experience:  9+ years being an appliance technician with factory training.
Type Your Appliance Question Here...
Tyler Z. is online now
A new question is answered every 9 seconds

My Bosch Nexxt Series Mistcare Dryer MD # XXXXX will

Resolved Question:

My Bosch Nexxt Series Mistcare Dryer MD # XXXXX will not heat up on any cycle and I cannot find a service person who can work on this machine in this area. Can you E-mail me a wiring schematic and a parts list and I can fix it myself. Thanks Bill @[email protected]
Submitted: 5 years ago.
Category: Appliance
Expert:  Tyler Z. replied 5 years ago.
Hello, and thank you for using this service. I'll be helping you with your problem today.

Generally on this model the dryer will trip the high limit thermostat causing it to stop heating. This happens sometimes if the vent through your house is starting to get clogged, or if something large like a comforter was dried last and caused the air to stop recirculating properly. Either way, pull the dryer forward and unplug it. Remove all the screws going into the back panel of the dryer and remove the back panel. In the back right corner of the dryer is the heater flume. With the back panel removed you can see a small device with a tiny button on it attached to the side of the heating flume. This device has 2 wires going to it so be sure the dryer is unplugged. Push the button and if it clicks, the heat will reset and start working again.

Customer: replied 5 years ago.
Relist: Incomplete answer.
What I need is the wiring diagram and parts list incase this solution does not work. This problem did not happen while we were drying anything it happened when we started to dry some cloths the following day.
Expert:  Tyler Z. replied 5 years ago.
OK so below is a link to the parts diagram that you'll need to order any parts.


The schematic with the wiring diagram is inside the control panel on a sheet of paper, so if you remove the top panel and then the control panel, you should be able to see the schematic.

Tyler Z. and other Appliance Specialists are ready to help you