How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tyler Z. Your Own Question
Tyler Z.
Tyler Z., Appliance Doc
Category: Appliance
Satisfied Customers: 81218
Experience:  9+ years being an appliance technician with factory training.
Type Your Appliance Question Here...
Tyler Z. is online now
A new question is answered every 9 seconds

The display on the front of the dishwasher is stuck. The clean

Resolved Question:

The display on the front of the dishwasher is stuck. The clean light and all the top lights on the right are blinking. I can't reset. Canl you help.
Submitted: 6 years ago.
Category: Appliance
Expert:  Tyler Z. replied 6 years ago.
Hello, and thank you for using this service. I'll be helping you with your problem today.

This is just a bad control board unfortunately. There isn't anything you can do to fix this issue but to order and replace the control board inside the door of the dishwasher to fix the problem. Below is a link to the part you'll need to order and replace.


Customer: replied 6 years ago.
How do you replace the control panel? Do you need special tools. Is this part correct - AP4113560?
Expert:  Tyler Z. replied 6 years ago.
yes, that is the correct part number. You don't need any special tools. Just unplug the unit or turn the circuit breaker off. Then open the door and remove all the screws around the border of the inner door liner. Once the screws are removed, the door will split apart so you can replace the control board.

Customer: replied 6 years ago.
Does the control board just plug in then?
Expert:  Tyler Z. replied 6 years ago.
yep, very easy. Takes about 15 minutes to replace.

Tyler Z. and other Appliance Specialists are ready to help you