How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Bryan Your Own Question
Bryan, Home Appliance Technician
Category: Appliance
Satisfied Customers: 12156
Experience:  15 yrs. experience as a certified appliance technician.
Type Your Appliance Question Here...
Bryan is online now
A new question is answered every 9 seconds

I have a duet whirlpool washer when I start it on the normal

Resolved Question:

I have a duet whirlpool washer when I start it on the normal it. Stops and gives us an H F on the screen can you please help me troubleshoot
Submitted: 6 years ago.
Category: Appliance
Expert:  Bryan replied 6 years ago.

Hi,Welcome to Just Answer, My name isXXXXX will be helping you with your appliance issue today.

Sometimes this code comes up wrong but the meaning is below, first thing I would start with is remove the bottom panel under the door there will be three screws along the very bottom of this panel remove them and check your pump trap, if the machine is not draining fully or completely and there is water left it will not call for more water therefore the code will come up, unscrew the trap and pull it out and clean it, then try the machine again, let me know if this works thanks, Bryan



No water detected entering machine or Pressure switch trip not detected.

If after 30 seconds the control does not detect water entering machine and then valves will be turned off and the error code will be displayed.


If the control has turned the water valves on and after 8 minutes the flow meter has detected 10.5 gallons of water passing through it, but has not detected the pressure switch trip, the valves will be turned off and the error code will flash.


Press PAUSE/CANCEL twice to clear the display.
  • If there is no water in the unit:
    1. Make sure that both valves at the water source(s) are turned on all the way.
    2. Check for plugged or kinked inlet hoses or plugged screens in the inlet valves
    3. Verify inlet valve operation
  • If there is water in the unit:
    1. Verify Drain pump operation
    2. Pressure Switch Hose is in good condition and properly connected to Tub and Pressure switch
  • Verify there is not a siphon problem
  • Verify wire harness connections to:Inlet Valves, Pressure Switch, Drain Pump, Flow Meter, and Central Control Unit (CCU)
  • Check all hoses for possible leaks
  • Verify pressure switch operation
  • Verify flow meter operation
  • Verify CCU operation
Customer: replied 6 years ago.
Thank you - I got it workinv
Expert:  Bryan replied 6 years ago.
thats great, thanks , and please remember to press the green accept button if I've helped. well wishes, Bryan
Bryan and 3 other Appliance Specialists are ready to help you