How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask william Your Own Question
william
william, Home Appliance Technician
Category: Appliance
Satisfied Customers: 3034
Experience:  Major Home Appliance Technician Specialist Whirpool Certificate
13954826
Type Your Appliance Question Here...
william is online now
A new question is answered every 9 seconds

i have a matag bravos washer model number MTW6600TQO. when

Resolved Question:

i have a matag bravos washer model number MTW6600TQO. when you power on no water comes out and it makes a "grinding"sound
Submitted: 6 years ago.
Category: Appliance
Expert:  william replied 6 years ago.
What watervalve at the bottom did you change?
Customer: replied 6 years ago.
reculating vavle
Expert:  william replied 6 years ago.

Thats just the recirculation pump thats not the water valve i believe you changed the wrong part. You need to change the inlet water valve dispencer valve assembly.

 

 

 

 

 

Press the accept button this is how im paid for either suggesting or helping you today. Thank-you.

 

william and 2 other Appliance Specialists are ready to help you
Customer: replied 6 years ago.
are you talking about where the water lines screw into the back of the unit
Expert:  william replied 6 years ago.

Why did you change that pump to begin with?

Customer: replied 6 years ago.
that is what a guy on here said to replace not sure who it was
Expert:  william replied 6 years ago.
Sorry but what i meant was did you have this problem before and thats what that other tech said to do?
Customer: replied 6 years ago.

yes

Expert:  william replied 6 years ago.
Did he tell you to test anything first before telling you to go buy a part that you dont need?
Customer: replied 6 years ago.

no sir

 

Expert:  william replied 6 years ago.

Try this first i will give you another post here in a second. Tell me what it reads after this test is done.

 

 

 

Be sure the washer is in standby mode

(plugged in with all indicators off, or with

only the Clean indicator on).

2. Select any one button (except POWER,

START, and PAUSE/CANCEL) and follow

the steps below, using the same button

Press/hold

3 seconds

Release for

3 seconds

Press/hold

3 seconds

Release for

3 seconds

Press/hold

3 seconds

(remember the button

 

 

 

If this test mode has been entered successfully,

all indicators on the console

are illuminated for 5 seconds with 88

 

showing in the Estimated Time Remaining

two-digit display.

If indicators do not display as described

above, the press/hold/release

procedure above may not have been

performed within the time frame necessary

for successful entry. Repeat step

2 to ensure this was not the cause. If

still unsuccessful, see Diagnostic: Unsuccessful

Entry.

3. The program then checks for saved fault

codes:

If there are saved fault codes, see Diagnostic:

Saved Fault Codes.

If there are no saved fault codes, all

indicators on the console will momentarily

turn off, then turn back on with 88

 

displayed. After 5 seconds, the Automatic

test begins.