How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask RUSS Your Own Question
RUSS
RUSS, SERVICE TECHNICIAN
Category: Appliance
Satisfied Customers: 3666
Experience:  TECHNICIAN AND TEACHER
19031375
Type Your Appliance Question Here...
RUSS is online now
A new question is answered every 9 seconds

Hello Friends, Need a little help. I have a kenmore model

This answer was rated:

Hello Friends, Need a little help. I have a kenmore model 110.67902791 that runs but will not heat. Today I replaced the element (it was not broken but looked bad) and still no heat. any suggestions?

HELLO

You need to locate the below parts near the element, turn off power or unplug the dryer, disconnect the wires going to the parts shown and test them for continuity with a volt ohm meter. If one is OPEN replace that part. ALSO MAKE SURE YOU HAVE 220 VOLTS AT THE WALL OUTLET

thanks

Part 2893 (Click to enlarge)
Grid is 1 inch square
Item #
2893
Price
$22.00
In Stock?
Yes
Dryer cycling thermostat with internal bias heater, L155-25
Qty Add to Cart
Order now and this item will ship Monday. Or it's FREE!
Transparent Gray Bar
Part 2924 (Click to enlarge)
Grid is 1 inch square
Item #
2924
Price
$16.55
In Stock?
Yes
High-limit thermostat, 2 wire, 250 degree limit, 60 degree cool down before reset.
Qty Add to Cart
Order now and this item will ship Monday. Or it's FREE!
Part 2923 (Click to enlarge)
Grid is 1 inch square
Item #
2923
Price
$16.05
In Stock?
Yes
Thermal fuse, disposable, on exhaust duct
Qty Add to Cart

RUSS and other Appliance Specialists are ready to help you