How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Appliance Tech Larry Your Own Question
Appliance Tech Larry
Appliance Tech Larry, Home Appliance tech
Category: Appliance
Satisfied Customers: 19183
Experience:  Over 35 years of in home appliance repair and service
14308609
Type Your Appliance Question Here...
Appliance Tech Larry is online now
A new question is answered every 9 seconds

My GE spacemaker 2.0 Microwave Oven stops after about 3 seconds.

Resolved Question:

My GE spacemaker 2.0 Microwave Oven stops after about 3 seconds. Time then changes but all rest of lights remain the . Any suggestions ?


















oven
Submitted: 7 years ago.
Category: Appliance
Expert:  Mike replied 7 years ago.
Hi do you see any error codes on the screen such as F3 or F1 ?
Customer: replied 7 years ago.
No- the screen goes back to original look
Expert:  Mike replied 7 years ago.
Ok sounds like a problem with the control board to me, I am going to pass you over to a friend of mine who has a little more knowledge then I do and may have seen this before. Don't respond until he helps you. Mike
Expert:  Appliance Tech Larry replied 7 years ago.
does the panel go blank or does it just shut off?
Customer: replied 7 years ago.
iT JUST SHUTS OFF
Expert:  Appliance Tech Larry replied 7 years ago.
can you program it again and run it right away?
Customer: replied 7 years ago.
Yes and I will now
Expert:  Appliance Tech Larry replied 7 years ago.
try it now and tell me what it does and tell me if you hear a loud buzz or hum
Customer: replied 7 years ago.
No buzz or hum. The screen is the same except the time does not stay correct after it was set correct
Expert:  Appliance Tech Larry replied 7 years ago.
you have a bad control board and it will have to be replaced to fix this problem
Appliance Tech Larry, Home Appliance tech
Category: Appliance
Satisfied Customers: 19183
Experience: Over 35 years of in home appliance repair and service
Appliance Tech Larry and 2 other Appliance Specialists are ready to help you