How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Appliance Tech Larry Your Own Question
Appliance Tech Larry
Appliance Tech Larry, Home Appliance tech
Category: Appliance
Satisfied Customers: 19183
Experience:  Over 35 years of in home appliance repair and service
Type Your Appliance Question Here...
Appliance Tech Larry is online now
A new question is answered every 9 seconds

getting a f11 oo f13 code when using oven. Sometimes when preheating

Resolved Question:

getting a f11 oo f13 code when using oven. Sometimes when preheating and other time after using when cooling down. Now and then it works fine. Getting it when baking or broiling. Kenmore(NNN) NNN-NNNN checked temp probe and getting 1154 ohms
Submitted: 7 years ago.
Category: Appliance
Expert:  Appliance Tech Larry replied 7 years ago.


Runaway Temperature.

Shorted Keypad.

Bad Micro Identification.

Bad EEPROM Identification/Checksum error.

1. (F10 only) Check *RTD Sensor Probe & replace if necessary. If oven is overheating, disconnect power. If oven continues to overheat when the power is reapplied, replace EOC. Severe overheating may require the entire oven to be replaced should damage be extensive.

2. (F11, 12 & 13) Disconnect power, wait 30 seconds and reapply power.

3. (F11, 12 & 13) If fault returns upon power-up, replace EOC.

Appliance Tech Larry and 3 other Appliance Specialists are ready to help you
Customer: replied 7 years ago.
Can't seam to locate a EOC on the parts list? Is this "electric oven control" sounds expensive. In your opionion is it worthwhile to change this or get a new oven. As I looked at the answers provided I have seen F11,F13 and F30 codes at different times.From the list i points to this EOC
Expert:  Appliance Tech Larry replied 7 years ago.
it is the electronic oven control and yes its expensive but i can tell you to replace the range because its your range but i would check prices on new units if it was me