How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Appliance Man Your Own Question
Appliance Man
Appliance Man, Home Appliance Technician
Category: Appliance
Satisfied Customers: 9896
Experience:  Appliance tech 4 years
Type Your Appliance Question Here...
Appliance Man is online now
A new question is answered every 9 seconds

My Thermador C272TS built-in double oven has a problem. The

This answer was rated:

My Thermador C272TS built-in double oven has a problem. The upper oven wont heat to the correct temperature, it's about 20 degrees low. What's could be wrong and how do we fix it?

You need to calibrate the oven temp. Pres bake. The adjust temp to 500 and then hold bake. Your owners maual will tell you how to adjust it.
Customer: replied 7 years ago.

Thanks. Is there anything else to it? I don't have the owner's manual, oven came with the house.



The electronic thermostat has been preset to
0°F and accurately maintains its setting. If the
browning results are too light or too dark for your
preferences, you can raise or lower the setting.
To change the Calibration of the Oven
1. Turn off both ovens.
2. Touch and hold the pad in a double oven or
the OFF pad in a single oven; touch the BAKE pad.
3. 0 appears in the temperature digits; release all pads.
4. Touch BAKE and 0 changes in increments of 5 degrees
each time it is touched. The maximum adjustment is
± 35ºF. In Centigrade the range is ± 3ºC to 21ºC.
5. To complete the change, touch .
To calibrate the lower oven models: Repeat the
steps with this exception, touch the instead
of the pad.
Appliance Man and 3 other Appliance Specialists are ready to help you
Customer: replied 7 years ago.

Thanks, I'll give it a whirl.



Ok. Let me know if you run into problems.