How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask RUSS Your Own Question
RUSS
RUSS, SERVICE TECHNICIAN
Category: Appliance
Satisfied Customers: 3666
Experience:  TECHNICIAN AND TEACHER
19031375
Type Your Appliance Question Here...
RUSS is online now
A new question is answered every 9 seconds

How did i replace the Bellow on a Whirlpool washer model WFW8400TW00.

Customer Question

How did i replace the Bellow on a Whirlpool washer model WFW8400TW00. Also is there a Service Manual on line i can see.
Submitted: 8 years ago.
Category: Appliance
Expert:  RUSS replied 8 years ago.
<p><img src="http://www.applianceaid.com/image/Duet_boot_door.jpg" alt="" width="508" height="676" /></p><p>These are the best instructions I know of. It IS quite a job!</p>
RUSS, SERVICE TECHNICIAN
Category: Appliance
Satisfied Customers: 3666
Experience: TECHNICIAN AND TEACHER
RUSS and 2 other Appliance Specialists are ready to help you
Customer: replied 8 years ago.

This was no help at all

I still can not see how it is removed

Expert:  RUSS replied 8 years ago.
There are clamps on the boot and they ARE SECURED AS PER THE INSTRUCTIONS i SENT YOU IN THE TOP RIGHT OF THE INSTRUCTIONS!
Expert:  RUSS replied 8 years ago.
I CAN HELP YOU NO FURTHER SORRY
Customer: replied 8 years ago.
I know they are clamped on but your instruction sheet dose show how to get to them. How do you get them. ??
Expert:  RUSS replied 8 years ago.
THE SCREW IS AT THE UPPER RIGHT OF THE TUB IF IT IS NOT THERE YOU WILL HAVE TO HUNT IT! I wish I could do it for you!
Expert:  Appliance Tech Larry replied 8 years ago.
to replace the bellow you will take the screws out of the back of the top, slide back and remove, take the lower front panel off and open the door, remove the spring clip around the edge of the front of the door seal, remove the two screws at the bottom of the door panel, at the top take out the dispenser and remove the screw inside, remove the screws on top of the control panel and remove and lay on top of the washer, remove the two screws at the top holding the front panel on and set aside, loosen the screw on the clamp on the back of the bellows and pull the bellows off ,,, mark the top of the bellows before removing so you can install the new one in the same spot and put back together / thanks
graphic
graphic
graphic
graphic