How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask I.can Your Own Question
I.can
I.can, Home Appliance Technician
Category: Appliance
Satisfied Customers: 1365
Experience:  10 Years of experience installing and repairing appliances
13086822
Type Your Appliance Question Here...
I.can is online now
A new question is answered every 9 seconds

model sf262lxsw oven not igniting you get three klunks and

Customer Question

model sf262lxsw oven not igniting you get three klunks and then nothing after you push bake and then start if you dont push start you get an error code p5h
Submitted: 8 years ago.
Category: Appliance
Expert:  I.can replied 8 years ago.

Hi YaCustomer
Whirlpool has no p5h error code.
Perhaps you had a typo.

Are you perhaps in the UK ?

Below are all the Error codes for your range
WHIRLPOOL
Range/Stove Oven 30" Free-standing, Models SF3…& 24" Built-In
Failure
Code
Condition
Check/Repair
F2
Oven temperature above specifications
8-pin connector oven temperature sensor to the Electronic Range Control (ERC)
F3
Open oven temperature sensor
Check wiring harness, replace oven temperature sensor if necessary
F4
Shorted oven temperature sensor
Check wiring harness, replace oven temperature sensor if necessary
F5
Pushbutton stuck
Check for binding of pushbuttons and control panel glass. If OK, replace touch panel
F6
Computer logic interrupted (timing)
Replace Electronic Range Control (ERC)
F7
Computer logic interrupted (lock motor)
Replace Electronic Range Control (ERC)
F8
Computer logic interrupted
Replace Electronic Range Control (ERC)
Customer: replied 8 years ago.
I am in u.s. Iam not getting any error codes after Ipush start just three klunks and nothing.
Expert:  I.can replied 8 years ago.
You said, if you dont push start you get an error code p5h
Customer: replied 8 years ago.
Yes
Customer: replied 8 years ago.
it is not f5 but it is p5h and all buttons are working doing what they are supose to do it will try to start but no ignition
Customer: replied 8 years ago.
any way of testing I don't believe in shotgun diagnostics is there anyway to get wiring flow chart?
Expert:  I.can replied 8 years ago.
If you pull out the storage drwer at the bottom there should be a small plastic bag with the wiring diagram in side stuck to the inner wall of the rang.
Or on the rear outside wall behind the range.
I'll look for it myself and send it to you.
I may be able to send you the complete repair manual for your range.
I will look for it now. be back .
Expert:  I.can replied 8 years ago.
HiYaCustomer

I believe this will help you find the problem.


The tech sheet you need for your range is here at this location.
This is what we use.

http://www.servicematters.com/docs/wiring/Tech%20Sheet%20-%209763044.pdf


Let me know how it goes
Good Luck, God bless.


I.can and 2 other Appliance Specialists are ready to help you
Customer: replied 8 years ago.

Thank you very much, this is what I was looing for. Should have asked for tech sheet in the first place.Sorry..

 

Thanks again,Customer

Expert:  I.can replied 8 years ago.
You are welcome.
God Bless