Appliance

Need appliance repair help? Ask a technician for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Appliance Questions
I have replaced the spluch, actuator, capacitor, and new
I have replaced the spluch, actuator, capacitor, and new drive belt on top load washer WTW4800XQ2. Runs through Test properly without any faults taking place. When I put a small load in washer and try… read more
Master Tech
Master Tech
Vocational, Technical or Trade Scho
18,128 satisfied customers
Have a Whirlpool Duet Washer (GHW9100LW1) that we replaced
Have a Whirlpool Duet Washer (GHW9100LW1) that we replaced rear & inner stainless tub on last November as bearings were shot. It's been working great until last night. Started making funny noise again… read more
Master Tech
Master Tech
Vocational, Technical or Trade Scho
18,128 satisfied customers
Maytag washer started making a grinding/ clunking noise when
Maytag washer started making a grinding/ clunking noise when it agitates. Then last night it just stopped and it was full of water. This morning I was able to turn it on and the water drained. Now I j… read more
Tyler Z.
Tyler Z.
Home Appliance Technician
Bachelor's Degree
97,111 satisfied customers
maytag washer makes a clunking noise when it agitates during
maytag washer makes a clunking noise when it agitates during wash cycle....no problems just the noise convinces my wife its broken, but its not...it washes, rinses, spins great...just clunks while it … read more
Tyler Z.
Tyler Z.
Home Appliance Technician
Bachelor's Degree
97,111 satisfied customers
My neptune washer will not spin out the water and makes a lot
My neptune washer will not spin out the water and makes a lot of clunking noises. I pulled off the bbak and saw that the puley and belt are cutting into the drum case. the belt seems to be rubbing aga… read more
Tyler Z.
Tyler Z.
Home Appliance Technician
Bachelor's Degree
97,111 satisfied customers
our front load washer wouldnt go through the spin cycle. after
our front load washer wouldn't go through the spin cycle. after trying the obvious reasons we took the back off to see the belt had come loose. We put it back on but now the drum doesn't seem to sit r… read more
Randy 43
Randy 43
appliance technician
Vocational, Technical or Trade Scho
3,850 satisfied customers
Hi - My Maytag Neptune washer is making a loud, high-pitched
Hi - My Maytag Neptune washer is making a loud, high-pitched rattle during the spin cycle. It's accompanied by something that sounds similar to a grinding noise. These sounds occur in the regular, whi… read more
Tyler Z.
Tyler Z.
Home Appliance Technician
Bachelor's Degree
97,111 satisfied customers
I have a 10 year old Maytag washing machine model # MAV6000AWN,
I have a 10 year old Maytag washing machine model # XXXXX Serial # XXXXX last week I noticed the water pump was sluggish and making a little bit of noise but functioning, last night my wife went to us… read more
RUSS
RUSS
Vocational, Technical or Trade Scho
3,654 satisfied customers
I have a maytag neptune front loader. It started making a clang
I have a maytag neptune front loader. It started making a clang sound when it was spinning (sounded like a belt buckle or something was inside clanging) Now it will not spin at all. Tried to start a l… read more
Bob L Your  Appl Pal
Bob L Your Appl Pal
Owner
Vocational, Technical or Trade Scho
7,404 satisfied customers
I have a Maytag top loading washer, on the spin cycle, it wont
I have a Maytag top loading washer, on the spin cycle, it won't spin and makes a "machine gun" noise. What's wrong?… read more
John
John
Home Appliance Technician
Vocational, Technical or Trade Scho
13,453 satisfied customers
My Maytag Washer is a neptune front load. Model # XXXXX
My Maytag Washer is a neptune front load. Model # XXXXX Serial # XXXXX On my washer inside the rear access panel there is a wheel that causes the the clothes to spin, and the belt that turns this whee… read more
Robert
Robert
Owner/Lead Technician
Vocational, Technical or Trade Scho
1,596 satisfied customers
I have a Maytag Neptune front-loading washer. Model No. MAH8700AWW;
I have a Maytag Neptune front-loading washer. Model No. MAH8700AWW; Serial No. 12535465GT. The drum will not spin. The only manual that I can find is from my previous washer, a model MAH5500AWW that I… read more
Tom Johnston
Tom Johnston
Home Appliance Technician
Vocational, Technical or Trade Scho
8,007 satisfied customers
I have a Maytag Atlantis washing machine which just died while
I have a Maytag Atlantis washing machine which just died while washing some bathroom rugs. The machine stopped after the rinse cycle and will not spin. The tub is still full of water., the machine sme… read more
Tom Johnston
Tom Johnston
Home Appliance Technician
Vocational, Technical or Trade Scho
8,007 satisfied customers
I have a Maytag washing machine. Sometimes, during the agitation
I have a Maytag washing machine. Sometimes, during the agitation cycle or the spin cycle begin, a loud growling sound is made by the mechanical parts under the washer. When the sound occurs during the… read more
Tom Johnston
Tom Johnston
Home Appliance Technician
Vocational, Technical or Trade Scho
8,007 satisfied customers
My maytag neptune model number mah4000aww threw a belt off
My maytag neptune model number mah4000aww threw a belt off the back. I found the belt lying on the floor. Before when the belt was on though it made a really loud jet engine noise. A loud whurring whe… read more
Appliance Tech Larry
Appliance Tech Larry
Outside inhome service tech
High School or GED
19,156 satisfied customers
Frigidaire Tumble Action washer belt is slipping. The model
Frigidaire Tumble Action washer belt is slipping. The model (I think) is FLW105 12/04.The washer during spin cycles was making loud popping noises. Eventually it just stopped spinning entirely. Remove… read more
Tom Johnston
Tom Johnston
Home Appliance Technician
Vocational, Technical or Trade Scho
8,007 satisfied customers
I have a Maytag Neptune Front Load Washer (Model No: MAH4000AWQ).
I have a Maytag Neptune Front Load Washer (Model No: MAH4000AWQ). I ordered a new drive belt (Part No: 12001788). It seems like the belt is too short to fit, is there a special tool or tip to get the … read more
Tom Johnston
Tom Johnston
Home Appliance Technician
Vocational, Technical or Trade Scho
8,007 satisfied customers
my maytag washer is not spinning or agitating, I looked to
my maytag washer is not spinning or agitating, I looked to make sure the belt is not broken but it seemed loose. It came off with no effort. I spun the pulleys manually and the agitator moved but when… read more
Chas
Chas
Master Appliance Repair Technician
Vocational, Technical or Trade Scho
9,421 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Thank you for the expeditious answer. It's good to know you're out there and awake in the wee hours when I finally have time to ask questions about my Jenn Air.

JeanRiverhead, NY

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

< Previous | Next >

Meet the Experts:

John

John

Home Appliance Technician

13,453 satisfied customers

Appliance repair business owner for over 43 years.

Tom Goellner

Tom Goellner

Home Appliance Technician

1,708 satisfied customers

32 yrs. experience servicing major appliances and HVAC equipment.

Tyler Z.

Tyler Z.

Home Appliance Technician

97,111 satisfied customers

11+ years being an appliance technician with factory training.

Kelly

Kelly

Appliance Technician

23,367 satisfied customers

Highly accurate diagnostician with over 30 years experience!

The Home Smithy

The Home Smithy

Home Appliance Technician

6,148 satisfied customers

30 years repairing appliances

william

william

Home Appliance Technician

3,018 satisfied customers

Major Home Appliance Technician Specialist Whirpool Certificate

John

John

restaurant equipment technician

2,103 satisfied customers

25+ years experience. I'm now employed by a commercial cooking equipment service company

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x