Agriculture and Farm Equipment

Agriculture and farm Equipment repair questions? Ask a mechanic.

Connect one-on-one with {0} who will answer your question

Related Agriculture and Farm Equipment Questions
Trying to connect the hydrolics lines from a batt wing bush
Trying to connect the hydrolics lines from a batt wing bush hog to the rear hydronic lines on a 525 Belarus tractor . This tractor only has three leavers two for the front end loader and one that oper… read more
dd85
dd85
Service Manager
20 years Service Manager at Dealersh
227 satisfied customers
Clutch master cylinder had an external oil leak, replaced
clutch master cylinder had an external oil leak, replaced the cylinder with a new one, bled the system. tractor did not want to release to shift. this has been a problem with this tractor since the cu… read more
Dan
Dan
Technician
Auto Mechanics 1&2/diesel mech
13,077 satisfied customers
2000 deere 7210. Our 3 point hitch on our Deere 7210 won't
Our 3 point hitch on our John Deere 7210 won't go down unless we push it down with the loader tractor. If we get the plough hooked on, the weight of the plough will push it down as if there is nothing wrong. We just had the lift cylinders rebuilt, and as a result know that all the pins are free because when we took it apart, everything was free and moved up and down manually. When we put the rebuilt cylinders back on, nothing had changed. What should we do next? … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
2,239 satisfied customers
I have j d 5085 m with power beyond hyd hook up an jd 7200
I have j d 5085 m with power beyond hyd hook up an jd 7200 Valium 4 row planter . Hook up to planter an set vacuum pressure an made one pass about 400 ft an hyd oil temp warning light came on stop tra… read more
Dan
Dan
Technician
Auto Mechanics 1&2/diesel mech
13,077 satisfied customers
2006 international 4300. rear brakes, new calipers, new
2006 international 4300. rear brakes, new calipers, new rotors, bearings good and adjusted properly. came back to the shop after about 50 miles and rear brakes where smelling and hot. Moved the rotors… read more
Dan
Dan
Technician
Auto Mechanics 1&2/diesel mech
13,077 satisfied customers
Looking for a tech that is familiar with case ih 290
Looking for a tech that is familiar with case ih 290 hydraulic issues. On bank 1 and 4 the implement creeps down very fast when raised. How can we determine if this is a electronic issue or a solenoid… read more
Dan
Dan
Technician
Auto Mechanics 1&2/diesel mech
13,077 satisfied customers
On New Holland early '70's 1069 Stack Cruiser, brake master
On New Holland early '70's 1069 Stack Cruiser, brake master cylinder level went down. Upon refilling and attempting to bleed air out, I have finally gotten clean fluid at each wheel cylinder with no i… read more
Curtis B.
Curtis B.
Technician
Associate Degree
6,538 satisfied customers
I have a 7200 planter and one of the master cylinders won't
I have a 7200 planter and one of the master cylinders won't move, have checked the solenoid and is getting current and is good. With out the cylinder moving I can't get the clamp off to bleed and re-p… read more
Dan
Dan
Technician
Auto Mechanics 1&2/diesel mech
13,077 satisfied customers
I have a 1999 Deere 1770 16 row planter. Last year we
I have a 1999 John Deere 1770 16 row planter. Last year we started have the wings slowly start sagging to a point of having to bleed lift cylinders and cycle to level. We rebuilt master plungers, repl… read more
Curtis B.
Curtis B.
Technician
Associate Degree
6,538 satisfied customers
I have a JD 1780 16\31 planter that has a wiring issue seedstar
I have a JD 1780 16\31 planter that has a wiring issue seedstar with a brown box monitor. the planter has an erratic occurance that at different times i will lose control of frame control the monitor … read more
Kevin
Kevin
2 years John Deere Tech school
235 satisfied customers
We have a 1770 John Deere 24 row 30 planter that when folded
We have a 1770 John Deere 24 row 30 planter that when folded and lifted for transport the high lift cylinders creep down and the planter tips one way or the other very dangerous on the road. Thank you… read more
Kevin
Kevin
2 years John Deere Tech school
235 satisfied customers
I have a JD 7000 12-30 front fold planter. it goes down fine
I have a JD 7000 12-30 front fold planter. it goes down fine but will only raise back up if I switch the box to trans and push the fold button. Have replaced old harness connections and O-rings in the… read more
Kevin
Kevin
2 years John Deere Tech school
235 satisfied customers
I have a Kubota D722 3 cyl diesel that Im currently preparing
I have a Kubota D722 3 cyl diesel that I'm currently preparing to rebuild. My local kubota dealer tells me that kubota internals really isn't their thing which seems quite ridiculous to me but anyway.… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
2,239 satisfied customers
I have a new to me 7920 JD, I am using a Ag Leader Integra
I have a new to me 7920 JD, I am using a Ag Leader Integra monitor that I took out of my 4650 JD that I used for controlling my sprayer last year with no problem. I am having a issue with the spray pr… read more
Kevin
Kevin
2 years John Deere Tech school
235 satisfied customers
bought 16 row John Deere 7000 front fold. In plant position
bought 16 row John Deere 7000 front fold. In plant position the right side lift cylinders settle. Took clips off cylinders on main frame and phased the cylinders but still settled overnight. What are … read more
Kevin
Kevin
2 years John Deere Tech school
235 satisfied customers
I have john deere 7000 16 row 30inch front fold planter. The
I have john deere 7000 16 row 30inch front fold planter. The wing wheels settle quite quickly when the planter is in plant when it is in trans or the tractor is off it will stay up all night. I have r… read more
tj
tj
Bachelor's Degree
457 satisfied customers
We are hooking up a JD 1790 16/32 CCS planter. When going from
We are hooking up a JD 1790 16/32 CCS planter. When going from the planter being folded in transport mode to plant mode, we are experiencing the left rear wheels dropping substantially lower than the … read more
Kevin
Kevin
2 years John Deere Tech school
235 satisfied customers
Alternator, battery, starter, what else if anythingl is needed
Alternator, battery, starter, what else if anythingl is needed to convert 1953 or 54 Ford jubilee tractor to a 12 volt system ?… read more
Curtis B.
Curtis B.
Technician
Associate Degree
6,538 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

6,538 satisfied customers

Technican turned service manager on multiple lines of equipment and rental equipment.

Wayne

Wayne

Journeyman

2,239 satisfied customers

34 + years as a mechanic

Chris (aka-Moose)

Chris (aka-Moose)

Technician

163 satisfied customers

24 years of experience diagnosing & repairing

cumminsdr

cumminsdr

Mechanic

43 satisfied customers

Cummins field tech

dieseldan55

dieseldan55

Mechanic

42 satisfied customers

Road mechanic for Volvo Construction Equipment.

Cat Man

Cat Man

Cat Engine Expert

37 satisfied customers

I am ASE Master Certified.

MowerDocMD

MowerDocMD

Technician

33 satisfied customers

Own LaGrange Small Engine Repairing farm tractors and equipment

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x