Agriculture and Farm Equipment

Agriculture and farm Equipment repair questions? Ask a mechanic.

Ask an Expert,
Get an Answer ASAP!

Related Agriculture and Farm Equipment Questions
I am trying to replace the hopper on my Deere Z235 mower.
i am trying to replace the hopper on my John Deere Z235 mower. There are rivets attaching the plastic hopper to the metal frame and I am wondering how to get them off and then replace them. … read more
Curtis B.
Curtis B.
Technician
Associate Degree
4,545 satisfied customers
I have a international 3400a loader/backhoe and broke the
I have a international 3400a loader/backhoe and broke the left rear axle shaft at the wheel flange. I am having a hard time locating the 3400. Is there any other loaders /tractors that used the same a… read more
MowerDocMD
MowerDocMD
Technician
33 satisfied customers
2006 international 4300. rear brakes, new calipers, new
2006 international 4300. rear brakes, new calipers, new rotors, bearings good and adjusted properly. came back to the shop after about 50 miles and rear brakes where smelling and hot. Moved the rotors… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
957 satisfied customers
Was at a collectors show over the weekend and received some
Hi. Was at a collectors show over the weekend and received some advice about a JD 3010 diesel narrow front end/tricycle....to check how many were manufactured, how rare. Ours is rough, not running, ha… read more
Curtis B.
Curtis B.
Technician
Associate Degree
4,545 satisfied customers
Curtis, I have a Kubota M 6950 DT farm tractor an over the
Hi Curtis, I have a Kubota M 6950 DT farm tractor an over the last couple of months the rear left hand wheel has lock up (after the brakes were applied). Selecting reverse then forward again didn't re… read more
Curtis B.
Curtis B.
Technician
Associate Degree
4,545 satisfied customers
My JX 55 r4 tractor front tire came loose and upon removal
my JX 55 r4 tractor front tire came loose and upon removal of the tire there appears to be a leak. What could be the problem?… read more
Curtis B.
Curtis B.
Technician
Associate Degree
4,545 satisfied customers
1943 Allis Chalmers C - Restored Engine and other mechanical
1943 Allis Chalmers C - Restored Engine and other mechanical parts about 1 year ago. Drove the tractor about 50 miles total, and I started to notice a slight noise coming from the area where the torqu… read more
Curtis B.
Curtis B.
Technician
Associate Degree
4,545 satisfied customers
I have a Ford 841 Powermaster (1958?) Tractor and am
Hi. I have a Ford 841 Powermaster (1958?) Tractor and am changing the fluids as there is some water in the transmission, and perhaps the hydraulics and differential as well. I intend to use 80/90 Gear… read more
Curtis B.
Curtis B.
Technician
Associate Degree
4,545 satisfied customers
HelloI have never used type of set up before and I do have
Hello I have never used type of set up before and I do have a question. Can you explain to me how this works regarding a response to my question? I live in Brantford Ontario Canada and I am considerin… read more
Wayne
Wayne
Journeyman
11,552 satisfied customers
not sure if you can help but here goes. i have a Chinese tractor
not sure if you can help but here goes. i have a Chinese tractor feng shue i think is brand. My throw out bearing has failed. China stole a lot of designs from other manufacturers,so i wonder if any p… read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
696 satisfied customers
I have 3 different john deere 5020s and they all are leaking
I have 3 different john deere 5020's and they all are leaking hydraulic oil between engine and transmission. Already split one tractor 3 times and replaced seals and pilot bearing and them shaft, but … read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
696 satisfied customers
I have a 2005 Branson 3510. The rear hydraulics started leaking
I have a 2005 Branson 3510. The rear hydraulics started leaking down when sitting with the engine off. When the engine is running at any speed any implement attached to the back gets a little bounce i… read more
dd85
dd85
Service Manager
20 years Service Manager at Dealersh
223 satisfied customers
I have a Kubota D722 3 cyl diesel that Im currently preparing
I have a Kubota D722 3 cyl diesel that I'm currently preparing to rebuild. My local kubota dealer tells me that kubota internals really isn't their thing which seems quite ridiculous to me but anyway.… read more
Wayne
Wayne
Journeyman
11,552 satisfied customers
I have 1995 Case/IH tractor with a NTA-855-A engine. At 7020
I have 1995 Case/IH tractor with a NTA-855-A engine. At 7020 Hrs. a local independent mechanic recommended that I should install new main and rod bearing as preventive maintenance. The tractor was run… read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
696 satisfied customers
I have two 1992 Fordson Model Fs in my barn. Have been sitting
I have two 1992 Fordson Model F's in my barn. Have been sitting for years and do not run. They are complete. One has open rear wheels and the second the rear wheels are cover with skirts. My grandfath… read more
Curtis B.
Curtis B.
Technician
Associate Degree
4,545 satisfied customers
I have an old 1956? MF50 gas tractor. While old, it has always
I have an old 1956? MF50 gas tractor. While old, it has always run well. Recently it started sputtering and dying when under load. I replaced every electrical wire, no change, replaced plugs, cap, rot… read more
Curtis B.
Curtis B.
Technician
Associate Degree
4,545 satisfied customers
I have and old 1941 Farmall A restoration project. I'm
I have and old 1941 Farmall A restoration project. I'm trying to keep everything OEM. Having a problem finding out how the starter linkage is mounted. In some pictures I see it goes through the square… read more
Expert
Expert
I have four rk70 stationary engines. All four have had the
I have four rk70 stationary engines. All four have had the crank side main bearing fail after very few hours operation. I have reported it to Kubota and my supplier but they will not offer any assista… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
957 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

4,545 satisfied customers

Technican turned service manager on multiple lines of equipment and rental equipment.

Wayne

Wayne

Journeyman

11,552 satisfied customers

34 + years as a mechanic

dieseldan55

dieseldan55

Mechanic

42 satisfied customers

Road mechanic for Volvo Construction Equipment.

Cat Man

Cat Man

Cat Engine Expert

36 satisfied customers

I am ASE Master Certified.

MowerDocMD

MowerDocMD

Technician

33 satisfied customers

Own LaGrange Small Engine Repairing farm tractors and equipment

Chris (aka-Moose)

Chris (aka-Moose)

Technician

22 satisfied customers

16 years of experience

JBFixxer

JBFixxer

Mechanic

21 satisfied customers

16+ years experience, hydraulics,hydrostatics, engines, fuel injection systems. And everything in between.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x