Agriculture and Farm Equipment

Agriculture and farm Equipment repair questions? Ask a mechanic.

Connect one-on-one with {0} who will answer your question

Related Agriculture and Farm Equipment Questions
Just bought a used jd 5525(I think it was used for spraying)
just bought a used jd 5525(I think it was used for spraying) the three point lift will not respond. It will not go up or down. I think I must adjust the hydralic flow by a valve controlled behind the … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,097 satisfied customers
I have an 8840 and the implement hydraulics stopped working,
Dan I have an 8840 and the implement hydraulics stopped working, are they run by a different pump than the main in the front? Steering etc seems fine. Thx Todd … read more
Mikael
Mikael
Bachelor's Degree
150 satisfied customers
I have a 8430 John Deere mfwd the hydraulic pump is staying
I have a 8430 John Deere mfwd the hydraulic pump is staying in stroke I have checked the check valve in the load sense line for the scv stack and I have replaced the priority valve. My question is if … read more
Curtis B.
Curtis B.
Technician
Associate Degree
6,799 satisfied customers
I just purchased a 2005 Deere 6420, and it has a hydraulic
I just purchased a 2005 John Deere 6420, and it has a hydraulic system issue. Most notably, the steering is very stiff, and the 3 pt raises very slowly. Raising RPM's to maximum makes almost no differ… read more
Curtis B.
Curtis B.
Technician
Associate Degree
6,799 satisfied customers
JD 4210 compact utility tractor: October a year ago, I was
October a year ago, I was using a scraper blade on rear of tractor when the rockshaft arms just fell all the way down. I serviced the rockshaft filter to no avail. I then drained all the hydraulic oil and changed the suction filter and the filter screen, hydraulic filter and replaced the hydraulic oil. Immediately started the tractor and the rockshaft arms began working again. However, the tractor since that time has seemed sluggish and has not performed to its peak. I have changed both air filters, fuel filters, drained and cleaned the fuel tank, replaced the fuel lines, checked and cleaned the radiator and nothing changes the loss of power I have experienced. Today, while cutting grass, the rockshaft arms fell to their full down position and I wasn't even using the rockshaft control lever. Any thoughts or ideas on what's wrong with with the tractor and how to correct it will be sincerely appreciated. … read more
Curtis B.
Curtis B.
Technician
Associate Degree
6,799 satisfied customers
My jd 6300 priorty valve has 600psi on both ends of the
my jd 6300 priorty valve has 600psi on both ends of the spool . an thats telling the pump to pump when its not supost too. there 4 tractor is under contin. load . load sent presher from stireing is 0p… read more
Kevin
Kevin
Technician
2 years John Deere Tech school
754 satisfied customers
JD 6405 rockshaft tries to keep on pushing up when already
JD 6405 rockshaft tries to keep on pushing up when already at the top an it creeps upward when in HCU20 cal mode … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,097 satisfied customers
1972 JD 1520 ag tractor new hyd.pump three point and
1972 JD 1520 ag tractor new hyd.pump three point and steering try to work it has remote hyd. connections also. thx… read more
JBfixer
JBfixer
Mechanic
Vocational, Technical or Trade Scho
210 satisfied customers
I have a john deere 4440 with hydraulic issues, remotes and rockshaft
I have a john deere 4440 with hydraulic issues, remotes and rockshaft aren't functioning at all, power steering is tight when sitting but works when tractor is in motion. pressure tested at the pressu… read more
Kevin
Kevin
Technician
2 years John Deere Tech school
754 satisfied customers
I Have a John Deere 6410. The hydraulic pump whines when I
I Have a John Deere 6410. The hydraulic pump whines when I go above an idle. (Fluid level is full) It sounds like it is under a constant load. The tractor rpms will only go up to about 1500 rpm unless… read more
Kevin
Kevin
Technician
2 years John Deere Tech school
754 satisfied customers
I have a John Deere 2520 row crop tractor. I have been working
I have a John Deere 2520 row crop tractor. I have been working the bucket loader off the rear remotes for a long time and have had less and less pressure. I have read that I probably ruined the transm… read more
Curtis B.
Curtis B.
Technician
Associate Degree
6,799 satisfied customers
I have a JD 6300 Eruo Edition, I am trying to install a Power
I have a JD 6300 Eruo Edition, I am trying to install a Power Beyond for a Joy sick control for the loader and having trouble getting it to work correctly. I have the new redigned Rockshaft valve on i… read more
Kevin
Kevin
Technician
2 years John Deere Tech school
754 satisfied customers
I have a JD 4640 with Quad transmission. She suddenly lost
I have a JD 4640 with Quad transmission. She suddenly lost her 3 pt hitch and hydrolic outlets. I still can steer and have brakes. Fluid level is good. What should I look at?… read more
Kevin
Kevin
Technician
2 years John Deere Tech school
754 satisfied customers
I have a 6410 john Deere we took off the hydraulic remote valve
I have a 6410 john Deere we took off the hydraulic remote valve to put springs in the top of it put it on now we have no steering . we can move one valve into load and the steering will work… read more
Kevin
Kevin
Technician
2 years John Deere Tech school
754 satisfied customers
I have a jd 4440 power shift. I changed the rock shaft and
I have a jd 4440 power shift. I changed the rock shaft and seals now the hydraulics Don't work… read more
Kevin
Kevin
Technician
2 years John Deere Tech school
754 satisfied customers
Jd 2640 farm tractor. 146 loader, chatters as if low oil from
Jd 2640 farm tractor. 146 loader, chatters as if low oil from pump. flow and pressure from charge pump in transmission checked ok with flow and pressure meters. O rings in selective control valve and … read more
Kevin
Kevin
Technician
2 years John Deere Tech school
754 satisfied customers
John deere 2955 overheating hydraulic oil. I am having an
John deere 2955 overheating hydraulic oil. I am having an issue with my 2955 overheating the oil when it is run for not a long period of time. I would like some help to diagnose it. I have changed the… read more
Curtis B.
Curtis B.
Technician
Associate Degree
6,799 satisfied customers
I have a john deere 5020 that I have not run in 6 years. The
I have a john deere 5020 that I have not run in 6 years. The hydrolics do not work so I cannot lift my plow. Any suggestions?… read more
Kevin
Kevin
Technician
2 years John Deere Tech school
754 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

6,799 satisfied customers

Technican turned service manager on multiple lines of equipment and rental equipment.

Wayne

Wayne

Journeyman

2,353 satisfied customers

34 + years as a mechanic

Chris (aka-Moose)

Chris (aka-Moose)

Technician

254 satisfied customers

24 years of experience diagnosing & repairing

cumminsdr

cumminsdr

Mechanic

44 satisfied customers

Cummins field tech

dieseldan55

dieseldan55

Mechanic

42 satisfied customers

Road mechanic for Volvo Construction Equipment.

Cat Man

Cat Man

Cat Engine Expert

37 satisfied customers

I am ASE Master Certified.

MowerDocMD

MowerDocMD

Technician

33 satisfied customers

Own LaGrange Small Engine Repairing farm tractors and equipment

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x