How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask acramstr Your Own Question
acramstr
acramstr, ASE Master Tech
Category: Acura
Satisfied Customers: 5332
Experience:  ASE master tech ,CA smog, ASE L1
8300270
Type Your Acura Question Here...
acramstr is online now
A new question is answered every 9 seconds

Po2279 code changed intake gasket map sensor. told timing

Customer Question

po2279 code changed intake gasket map sensor. told timing belt off all points line up. runs perfect.
Submitted: 1 year ago.
Category: Acura
Expert:  acramstr replied 1 year ago.

Before you change any more parts. Reset the Idle position with a scan tool with the appropriate software. whenever the position of the throttle plate moves from its average position due to a change in manifold pressure it can set this code. Usually we see this pop up after the throttle body is cleaned or the valves are adjusted. So removing the head could easily set this code. Here is the procedure from the manual.

1. Go to INSPECTION MENU in the HDS, and select ETCS TEST.
2. Select TP POSITION CHECK, and clear the throttle position learned value.
3. Turn off the ignition, then, turn it back on.
4. Reset the ECM/PCM.
5. Do the idle learn procedure.( let car idle for 10 min warmed up with all loads off)

Customer: replied 1 year ago.
WAS THE THROTTLE BODY GASKET INSTALLED IN THE WRONG POSITION. THANKS ANYWAY.