Acura

Acura repair questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Acura Questions
Car been idleing bad dieing cutting out wen worm but fine
hey my car been idleing bad dieing cutting out wen worm but fine wen cold pulled codes p1381 and later then p1361 any help would be awsom … read more
Eric
Eric
Retired
N/A
35,620 satisfied customers
I have a 2003 xterra. Yesterday merging into the interstate
I have a 2003 xterra. Yesterday merging into the interstate on acceleration it started sputtering and shaking. I barely got up to 70mph. The sputtering only occurs around 2800 rpm and above. Below tha… read more
Chris (aka- Moose)
Chris (aka- Moose)
Acura Technician
Vocational, Technical or Trade School
234 satisfied customers
Shifting at gher rpms, I have chech, Sorry, If possible,
Shifting at higher rpms JA: Tell me a bit more about what's going on so he can help you best. Customer: I have chech JA: Are you hoping to fix this yourself? Customer: Sorry JA: Is there anything else… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
32,135 satisfied customers
My 2006 Acura TL 3.2 is experiencing a very rough idle. I
My 2006 Acura TL 3.2 is experiencing a very rough idle. I have narrowed it down to cylinder #5 having no spark at idle. When there is any gas pressed, the spark appears and is strong. It runs well and… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,665 satisfied customers
integra LS: I have an 96 Acura Integra LS. This is the problem:
I have an 96 Acura Integra LS. This is the problem: The car starts ok. After 2 min or driving 1/2 mile the engine stalls when the rpm drops below 2000. coming to a stop in traffic the car stalls. Then… read more
Chris
Chris
289 satisfied customers
Gear shift in my Acura will not move out of park. Help
I have an Acura 1999 3.2 TL. I recently got my transmission REBUILT AND SHORTLY after my rpm started flipping out and my gear shift would not move out of park unless I stick a screw driver in the side… read more
ddamato1986
ddamato1986
Bachelor's Degree
208 satisfied customers
2001 integra gsr: crank..car start and runs fine..gas pedal..rpms
I own a 2001 integra gsr and put a b18c jdm motor in..I swapped oil pumps and installed the crank angle sensor. The car start and runs fine except it wont rev higher than 3000rmp. When you do rev the … read more
MASTER  TECH
MASTER TECH
Acura Technician
Vocational, Technical or Trade Scho
5,767 satisfied customers
Acura tl: rev..sensors..all warning lights are on in the cluster
I've just replaced a acura tl base model engine with the same engine but i cant get it to rev over 3000 rpms, i've checked all sensors to make sure their connected right but it wont rev. It idles fine… read more
MASTER  TECH
MASTER TECH
Acura Technician
Vocational, Technical or Trade Scho
5,767 satisfied customers
hey i have a code 16 for my 94 integra and code 6 i fixed code
hey i have a code 16 for my 94 integra and code 6 i fixed code six but still get it would should i start tryin to fix for the injector issue?… read more
1smartcarguy
1smartcarguy
honda service technician
Associate Degree
607 satisfied customers
1991 acura integra gs: rpms..sorta cuts..accelerator the slower..pedal
hi, recently i bought a 1991 acura integra gs. There is no cel code but when i drive it and bring the rpms to around 4000, it just sorta cuts out. the more i press the accelerator the slower it goes, … read more
1smartcarguy
1smartcarguy
honda service technician
Associate Degree
607 satisfied customers
1991 Acura: Engine turns..fuel filter and spark at the spark plug.
1991 Acura Integra will not start. Engine turns over, there is gas at the fuel filter and spark at the spark plug.… read more
1smartcarguy
1smartcarguy
honda service technician
Associate Degree
607 satisfied customers
87 Integra LS: throttle..neutral, misfire can be detected as one revs
87 Integra LS 1.6L lower RPM/part throttle misfire and shake. Has gross polluter test result HC (1040 ppm measured vs 305 ppm GP max) at 15 Mph smog test. (CO? 2.93 vs max 0.8) SMOG OK at 25 Mph. 105 … read more
thebesthonda
thebesthonda
ASE MasterTechnician
High School or GED
785 satisfied customers
my check engine light on my 2000 acura integra is constantly
my check engine light on my 2000 acura integra is constantly blinking. My car feels sluggish on the go and it also idles rough. I was told that my #2 cylinder is not firing (misfiring)..what do i need… read more
Josh
Josh
Lead Technician
High School or GED
1,570 satisfied customers
Engine light on for ~ 4 weeks. OBD-II P1362 TDC sensor code
Engine light on for ~ 4 weeks. OBD-II P1362 TDC sensor code read. No sysmptoms of any kind. car starts normally and runs fine. Disconnected battery to reset light. Came back on after ~ 4 days - same c… read more
Jerry
Jerry
Service consultant
Vocational, Technical or Trade Scho
13,108 satisfied customers
1993 acura integra ls: 3000 rpm..wot( sluggish..rev..roll
hi i have a 1993 acura integra ls b18a1, i am having an issue. my ecm has a 43 code and it has an erratic hesitation. it seems to be dominate at lower rpm below 3000 rpm. it also seems to hesitate nea… read more
rubasu
rubasu
Acura Technician
Vocational, Technical or Trade Scho
21 satisfied customers
Im having idle problems with my b18, it seems to only happen
I'm having idle problems with my b18, it seems to only happen when its warm (it won't happen at night in the cold air, but will if its been sitting in the sun for a while). The check engine light will… read more
rubasu
rubasu
Acura Technician
Vocational, Technical or Trade Scho
21 satisfied customers
my engine cranks but the car wont start. i changed timing belt
my engine cranks but the car wont start. i changed timing belt and I checked spark and fuel… read more
Your Auto Inspector
Your Auto Inspector
Assistant Service Manager
In course of study for bachelor's d
847 satisfied customers
Integra..the ingnition coil, plugs, dist cap and roter..else works
My integra will not start, i have replaced the ingnition coil, plugs, dist cap and roter. Every thing else works. What else can it be?… read more
acramstr
acramstr
Shop foreman
Vocational, Technical or Trade Scho
5,427 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I took the Power Steering O-Ring service bulletin linked from JustAnswer to my Acura dealer, and not only did they no-charge the o-ring, they also replaced the power steering pump at no cost.

Gary RStevenson Ranch, CA

Thank you very much for saving my daughter and her family a lot of money on her Honda. You are definitely on my list for future help. Thanks, again.

FredUSA

I just heard from my mechanic. You were right...a $45.00 job. THANK YOU!! Your response was received in less than 10 minutes!!

Linda B.USA

Your answers were clear and the diagrams were perfect. Dealer wanted $87 for an hour of labor and even I did it in 15 minutes.

EdUSA

HONDA PLATINUM was great. I really appreciate his help. I was ready to trade my new Honda until he told me to wait until I got 3,000 miles on it and my gas mileage would get much better.

SummerUSA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

< Previous | Next >

Meet the Experts:

thebesthonda

thebesthonda

ASE MasterTechnician

785 satisfied customers

26 years experience

Kyle N.

Kyle N.

ASE Certified Tech

631 satisfied customers

Master ASE Tech, Ca. smog lic

George H.

George H.

ASE Certified Technician

469 satisfied customers

ASE Master Tech 15+ years w/L1 Drivability certification

HONDASERVICE7791

HONDASERVICE7791

TECHNICIAN

462 satisfied customers

OVER 20 YRS EXPERIENCE, OVER 10 YRS ACURA/HONDA EXPERIENCE

Andrew

Andrew

ASE Master Tech

350 satisfied customers

Master tech for 11 years.

Chris (aka- Moose)

Chris (aka- Moose)

Acura Technician

234 satisfied customers

16 years of experience

Don - Mo Lurch

Don - Mo Lurch

Acura Mechanic

147 satisfied customers

Aftermarket & Factory Mobile Electronics. Sales, Installation & Repair for 30 years. R/S, etc.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x