How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask vwnewton Your Own Question
vwnewton
vwnewton, VW Owner,ASE Master and L1 Advanced
Category: VW
Satisfied Customers: 307
Experience:  25 years of VW obsession turned into a job, last 15 years as a VW Tech.
13710235
Type Your VW Question Here...
vwnewton is online now
A new question is answered every 9 seconds

Volkswagen Eurovan CL: 1999 VW Eurovan V6 - engine shuts down

Customer Question

1999 VW Eurovan V6 - engine shuts down at speed when hot. Dealer found now problem. Runs OK cold ( Air temp less than 68F) .. Just had fuel pump and fuel filter replaced because of hard starting (cured that).
Submitted: 1 year ago.
Category: VW
Expert:  Wolfgang replied 1 year ago.
Hello i'm Wolfgang here to assist. was a scan test performed and any fault codes stored?thanks
Customer: replied 1 year ago.

Yes, and no fault codes show up.. no engine light on either..

i own a Ross Tech VAG COM, and nothing showed on it at the time..

Customer: replied 1 year ago.

Hello... Wolfgang...

Are you still there..??

Any suggestions..??

Expert:  Wolfgang replied 1 year ago.
i'm sorry for the delay bad storms has knocked out my internet service. ok i need readings of measure value block 32, 33 and maf readings when running cold and hot please thanks
Customer: replied 1 year ago.

What will

"measure value block 32, 33 and maf readings when running cold and hot"

these show and how do I get them..??

Any suspected condition..??

Expert:  Wolfgang replied 1 year ago.
well with your ross tech go to engine electronics then go to the tab read measure value blocks and then enter on the first field 032 then the second field 033 and have the car running and see what are the readings and report back . i need to see if the vehicle is running lean or rich first before condemning a part
Customer: replied 1 year ago.

VW dealer measured all values when troubleshooting this problem..

All within normal ranges

(I could not find the tab value block to measure this with VAG COM)..

Would ignition switch cut out at high temp. and no engine light..??

Expert:  Wolfgang replied 1 year ago.
if you look at the 2 pics first one shows where measured values and the second shows the screen then input the 032 and 033 #'s on the left to get readings. i do need the readings
Customer: replied 1 year ago.

Just answer server blocked me from sending screenshots..

Expert:  Wolfgang replied 1 year ago.
You have to send as a file

Related VW Questions