How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Don 'Mo Lurch' Your Own Que...
Don 'Mo Lurch'
Don 'Mo Lurch', Mechanic / Electronics
Category: UK Ford
Satisfied Customers: 20662
Experience:  Heavy Line Mech-, Mobile Electronics. Sales, Installation & Repair for 30 years. R/S, etc.
1609972
Type Your UK Ford Question Here...
Don 'Mo Lurch' is online now
A new question is answered every 9 seconds

Need diagram of timing marks 1996 4.0 v6

Customer Question

need diagram of timing marks for ford 1996 4.0 v6
Submitted: 11 months ago.
Category: UK Ford
Expert:  Don 'Mo Lurch' replied 11 months ago.

sorry for the delay............
.
Greetings...... “Hi, I’m Don (aka MOLurch) and I look forward to helping you!”
.
Click Attachments below

This vehicle is equipped with electronic engine control system. Engine idle speed, idle mixture and ignition timing are not adjustable. Ignition timing is computer controlled.

Vehicle Preparation

  • Key OFF
  • Electrical loads OFF (A/C, Heater, etc.)
  • Engine at normal operating temperature
  • Shift lever in PARK (A/T) or NEUTRAL (M/T)
  • Timing light connected

Procedure

  1. Start engine using ignition switch (Do NOT use a remote starter)
  2. Disconnect SPOUT connector
  3. Check base timing: It should be within ±2° of the specification found on the VECI underhood decal
  4. Reconnect SPOUT connector
    • Check for computed timing advance at 1500 RPM

.

IF you need more information, please ask "prior" to Rating.
.
Please do the right thing and leave a rating, using the rating system, so I may be credited for this Q&A.
.
NOTE: Do NOT Rate on how much TIME you waited, because I am not on 24 / 7 and I answer as soon as I see the question.
The question will still remain open for follow up questions if needed.
.
If for any reason, you can't rate my answer OKAY, GOOD, or EXCELLENT today.
Please reply and let me know why, so I can help more/better.
.
Rating is very Important to our Service
.

Customer: replied 11 months ago.
halo
do i need a special tool to set the two camchaft in there position
thanks
Expert:  Don 'Mo Lurch' replied 11 months ago.

you have the D O H C 4.0??

Customer: replied 11 months ago.
Sory
this car is a US version
Expert:  Don 'Mo Lurch' replied 11 months ago.

Do you have the D O H C 4.0??

.