How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Gallagher99 Your Own Question
Gallagher99
Gallagher99, FORD SENIOR /SPECIALIST TECHNICIAN
Category: UK Ford
Satisfied Customers: 3014
Experience:  SVQ LEVEL 3, QAULIFIED FORD SENIOR/SPECIALIST TECHNICIAN , ATA REGISTERD ,12 YEARS EXPERIENCE
17855046
Type Your UK Ford Question Here...
Gallagher99 is online now
A new question is answered every 9 seconds

Widow wipers not working, its not the fuse or the motor, the

Customer Question

Hi, widow wipers not working, its not the fuse or the motor, the fuse was changed and a new motor was tried
Submitted: 12 months ago.
Category: UK Ford
Expert:  Kevin replied 12 months ago.

Hi im kevin do you washers work?

Expert:  Kevin replied 12 months ago.

And what fuses have you checked ?

Customer: replied 12 months ago.
washers work, the fuse in the main fuse box was changed
Expert:  Kevin replied 12 months ago.

The fuse box in car correct

Customer: replied 12 months ago.
Expert:  Kevin replied 12 months ago.

Can you hear relay click when stalk is switched on ?

Customer: replied 12 months ago.
can hear a click
Expert:  Kevin replied 12 months ago.

Ok then you need to check wiring from gem unit to wiper motor i dont have wiring diagram for this il opt out another tech may have this

Customer: replied 12 months ago.
Ok thanks
Expert:  Gallagher99 replied 12 months ago.

Hi there good evening to you

Hopefully I will be able to assist you with your issue

Ok with the wiper switch set to low speed (2up on switch ) measure the voltage at the wiper motor multiplug across pins. 2 (green wire ) and pin 4 (black wire ) with multiplug dissconected (do you have 12 volts ) if you do connect the multiplug to the motor and check the voltage again across these pins 2&4 ) (either Nick into the wiring or back probe the multiplug if you have no voltage with multiplug connected this indicates an internal GEM. Module fault

If you need anymore help or advice on this issue please let me know

If you are Completely satisfied with my answer /advice

PLEASE RATE MY ANSWER

Kind regards ***** ***** and have a nice evening

Brian

Expert:  Gallagher99 replied 12 months ago.

Hi there

How did you get on with the advice supplied

Regards ***** *****

Brian

Related UK Ford Questions