How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08, ASE Certified Technician
Category: UK Car
Satisfied Customers: 22522
Experience:  ASE Master and Advanced level certified. Factory trained with 15 years dealership experience
Type Your UK Car Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

My 2008 Chrysler grand voyager engine started to cut off

Customer Question

JA: Hello. How can we be of help?
Customer: my 2008 Chrysler grand voyager engine started to cut off when i accelerate
JA: How old is the transmission? Have you checked the fuel filters?
Customer: after i change all the filters
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: p0102 and p0087 codes when i scan
JA: Anything else you think the mechanic should know?
Customer: 2.8 diesel engine
JA: OK. Got it. I'm sending you to a secure page on JustAnswer so you can place the $5 fully-refundable deposit now. While you're filling out that form, I'll tell the Mechanic about your situation and then connect you two.
Submitted: 11 months ago.
Category: UK Car
Expert:  sprinkles08 replied 11 months ago.

Hello and welcome to JustAnswer!

P0102 is for the MAP sensor and could be the sensor or wiring, but isn't likely to be related to the dying issue.

P0087 sets when fuel rail pressure is too low and could be related to the dying issue. If rail pressure is low enough then you'll have hesitation or dying issues.

Does it hesitate and run out of power as it dies?
Did the problem start after any work was done, an accident, etc?

Customer: replied 11 months ago.
Problem started 5
Miles after i change the air and fuel
I just notice the area next to heater conector on fuel filter housing is dump
Expert:  sprinkles08 replied 11 months ago.

Is it coming from the heater connector itself? Can you remove the connector to see if it or the heater are melted? The fuel leak is most likely the cause of this. You'll probably find the housing and connector are melted.

Customer: replied 11 months ago.
Someone alse suggested that is easy to breake when u change th fuel filter
I will order a houseing tomorrow
Expert:  sprinkles08 replied 11 months ago.

Check the connector for heat damage also. If there is heat damage then it will need to be replaced along with the housing.

Related UK Car Questions