How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Marty Your Own Question
Marty
Marty, European Car Expert
Category: UK Car
Satisfied Customers: 398
Experience:  ASE & Bosch Certified Master Tech. Over 30 years experience.
13230946
Type Your UK Car Question Here...
Marty is online now
A new question is answered every 9 seconds

I have a ford cougar 2 2001
, i have no speedo odo fuel

Customer Question

hi i have a ford cougar 2 2001
JA: Thanks. Can you give me any more details about your issue?
Customer: i have no speedo odo fuel or temp guages working also the service indicator and other lights are not working i am hoping its a fuse
JA: OK got it. Last thing — Ford Mechanics generally expect a deposit of about $18 to help with your type of question (you only pay if satisfied). Now I'm going to take you to a page to place a secure deposit with JustAnswer. Don't worry, this chat is saved. After that, we will finish helping you.
Submitted: 1 year ago.
Category: UK Car
Expert:  SARMIENTO22556 replied 1 year ago.

Hello, I will try to help you with your concern.

Is this a four or six cylinder vehicle?

Expert:  SARMIENTO22556 replied 1 year ago.

check fuse #30 (7.5 amp) in the under dash fuse panel

Customer: replied 1 year ago.
I have checked the fuse and it is fine I changed it just to be sure I have a 2.5 litre V6 engine
Expert:  SARMIENTO22556 replied 1 year ago.

is nothing working? not even the illumination when you turn on the headlights?

Customer: replied 1 year ago.
The ilumination works but the clock and the trip metre the odometer and speedometer do not
Expert:  SARMIENTO22556 replied 1 year ago.

try this test:

Self Diagnostic Mode

  1. To enter HEC self diagnostic mode with the engine off, simultaneously depress the message center UNITS and RESET buttons. Turn the ignition switch ON.
  1. To enter HEC self diagnostic mode with the engine running, simultaneously depress the message center UNITS and RESET buttons. Turn the ignition switch from ON to RUN, to start the engine.
  1. Release the RESET button first, then the UNITS button.
  1. The HEC will enter the gauge sweep test.
  1. To navigate to the following tests while in self diagnostic mode, depress the SELECT button. Depress the RESET button to navigate to the previous test:
Customer: replied 1 year ago.
I cannot seem to get the test to run the reset and units buttons seemed dead as I said before the clock and the trip metre are not working and the buttons do not seem to have any response
Expert:  SARMIENTO22556 replied 1 year ago.

ok you will need to do a pin out test on the signals coming into the cluster. Do you have a volt meter?

If all the signals in check good, the cluster is faulty

Customer: replied 1 year ago.
Thanks I will have to try tomorrow now as it is very dark
Expert:  SARMIENTO22556 replied 1 year ago.

ok let me know what you find